Calculate the range of the variable capacitor

Assignment Help Electrical Engineering
Reference no: EM131127840

For an FM radio receiver, the incoming wave is in the frequency range from 88 to 108 MHz. The tuner circuit is a parallel RLC circuit with a 4-µH coil. Calculate the range of the variable capacitor necessary to cover the entire band.

Reference no: EM131127840

Questions Cloud

Mortgage customers as can be for other types of bank loans : Lenders tend not to be as flexible about the qualifications required of mortgage customers as they can be for other types of bank loans. Why is this so?
A simplified model of the control system : A simplified model of the control system for regulating the pupillary aperture in the human eye is shown in Figure P9.12 [20].The gain K represents the pupillary gain, and τ is the pupil time constant, which is 0.5 s. The time delay 7" is equal to..
Why are the temperatures at la paz more moderate : Why are the temperatures at La Paz more moderate (tending toward average, i.e., less extreme) in every month and so consistent overall as compared to Concepcion?
What is the purpose of requiring that a borrower make a down : What is the purpose of requiring that a borrower make a down payment before receiving a loan?
Calculate the range of the variable capacitor : Calculate the range of the variable capacitor necessary to cover the entire band.
What are discount points, and why do some mortgage borrowers : What are discount points, and why do some mortgage borrowers choose to pay them?
What is the difference between a balloon loan and an amortiz : Most mortgage loans once had balloon payments; now most current mortgage loans fully amortize. What is the difference between a balloon loan and an amortizing loan?
What was the final index value after 20 years : An index had an average (geometric) mean return over 20 years of 3.8861%. If the beginning index value was 100, what was the final index value after 20 years?
What is the change in the value of the index from time : What is the change in the value of the index from Time = 0 to Time = 1 if the index is calculated using a value-weighted arithmetic mean?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the range of load resistances over the circuit

a) Determine the range of load resistances over which the circuit gives a constant Vout if Rs = 1500 kilo ohms and Vs = 150V. Assume the diode breakdown voltage is 100V and the maximum rated current is 100 mA.

  Determine and represent the signal

Fourier transform X(w)=Xreal(w)+j(Xi(w)). Determine and represent the signal y(w) that gives the fourier transform of Y(w)=Xi(w)+Xreal(w)e^exp(j2w).

  What will be the count in hexadecimal after 1000 pulses

A 10 Bit Ripple Counter has a 256KHz Clock Pulse. Assume thatthe counter starts at zero. What will be the count in Hexadecimal after 1000 pulses

  Define a saturated npn transistor

A saturated npn transistor has a base to emitter applied voltage of 0.6V. The collector to emitter voltage is 0.2V. The collector current is 12mA

  Find what is the maximum amplitude of the sine wave

A non-inverting amplifier with a closed loop gain of 1000V/V is designed using an opamp having an input offset voltage of 5mV and output saturation levels of ±13V. What is the maximum amplitude of the sine wave that can be applied at the input wit..

  What is the value of the rlc-circuit complex impedance

The input signal is 10 sin ( 2 pi 1592 t + 0degrees ) applied to a series RLC circuit with resistor R = 1000 ohm and inductor L = 0.2 H, and C = 0.1 micro F. what is The value of the total circuit complex impedance.

  What is the value of the smallest resistor

The voltage drops across three resistors in series are measured to be 10.0V, 15.0V, and 25.0V. If the largest resistor is 47.0 ?, what is the value of the smallest resistor?

  Determine the forces and the torque on the loop

A triangular loop is placed in the x-z plane. Assume that a dc current, I = 2A ,flows in the loop and that B = 30az mWb/m exists in the region. Find the forces and the torque on the loop.

  Explain how to derive the inputs to the multiplexers

Implement the 2-bit adder function (i.e., 2-bit binary number AB plus 2-bit binary number CD yields 3-bit result XYZ) using three 8:1 multiplexers. Show your truth table and how you derived the inputs to the multiplexers.

  Draw circuit that will have underdamped transient response

Given a course voltage of 10V, a source resistance of 10 ohms, a 10mH inductor, and a 5nF capacitor, choose a load resistance and draw a circuit that will have an underdamped (decaying sine wave) second order transient response.

  You want to generate a sinusoidal signal which frequency

you want to generate a sinusoidal signal which frequency f varies continuously and parabolically from 500 hz to 3500

  Determine the average current

Consider the battery charging circuit shown in Figure. The ac source has a peak value of 24 V and a frequency of 60 Hz. The resistance is 2 Ω, the diode is ideal, and VB = 12 V. Determine the average current.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd