Calculate the radiation pressure on the mirror

Assignment Help Physics

Reference no: EM13300283

A 25.5-mW laser beam of diameter 2.08 mm is reflected at normal incidence by a perfectly reflecting mirror. Calculate the radiation pressure on the mirror.

N/m2

Reference no: EM13300283

Questions Cloud

What is the maximum column load in kips that could be placed : What is the maximum column load in kips that could be placed on a 4-ft square temporary footing on a sand for which the standard resistance is about N=15 and the water table is at the surface

The sequence control structure : 1. the sequence control structure and the selection control structure?

What is the cost of common from retained earnings : Assume that Kish Inc. hired you as a consultant to help estimate its cost of common equity. You have obtained the following data: D0 = $0.90; P0 = $27.50; and g = 7.00% (constant). Based on the DCF approach, what is the cost of common from retaine..

Estimate the settlement of 10-ft and 5-ft square footings : Footings for a structure are to be built beneath a basement slab on a clay soil at a depth of 20ft below present ground level. The groundwater table is 15 ft below the ground surface. The soil-void ratio is about 0.87.

Calculate the radiation pressure on the mirror : A 25.5-mW laser beam of diameter 2.08 mm is reflected at normal incidence by a perfectly reflecting mirror. Calculate the radiation pressure on the mirror

Type of sport is factor in elite athletes resting heart rate : A study comparing the resting heart rate of four different types of elite athletes recruited: 10 cyclists, 10 triathletes, 10 soccer players, and 10 baseball players. The resting heart rate of each athlete was measured, and the following hypothesis w..

What force is required to stretch the spring by this amount : A load of 52.5 N attached to a spring hanging vertically stretches the spring 5.29 cm. What force is required to stretch the spring by this amount

What is the stress along the top edge and the bottom edge : A horizontal pre-stressing force of 500kN is applied to rectangler beam. the beam has a depth of 500mm and a width of 250mm. the force is applied at a distance of 80mm below the x-x axis.

C++ programs that compute the agreement for two vectors : In this assignment, you write C++ programs that compute the agreement for two given vectors (see Calculation 1 above). In these programs, in vectors A and B only nonzero elements (elements that are 1) are stored. We give you a function that gen..

User Account

All Pages