Calculate the pressure the plates exert on the air in plates

Assignment Help Electrical Engineering
Reference no: EM13254385

A capacitor is made with very large plates separated a distance d. The potential between the plates is V=1000 volts and d = 1mm.

a) Calculate the pressure the plates exert on the air between the plates.

b) If the air is replaced by a material of permittivity Xr = 8, what is the

Reference no: EM13254385

Questions Cloud

Increasing the capacity of the network : Increasing the capacity of the network, what would adding a T3 line do? Include the path and the protocol of the network.
What is the current in the circuit : A 6.00 V storage battery is connected to three resistors, 7.00 ?, 15.0 ?, and 20.0 ?, respec- tively. The resistors are joined in series. What is the current in the circuit
Explain what is the partial pressure of co : How do i figure out a mixture of 0.156 moles of C is reacted with 0.117 moles of O2 in a sealed,10.0L vessel at 500 K, producing a mixture of CO AND CO2. the total pressure is 0.640 atm. What is the partial pressure of CO
What are the five propositions of the davis model : What are the five propositions of the Davis model of corporate social responsibility? Which proposition would be the most valuable to you as a manager in guiding your social responsibility focus in an organization?
Calculate the pressure the plates exert on the air in plates : A capacitor is made with very large plates separated a distance d. The potential between the plates is V=1000 volts and d = 1mm. a) Calculate the pressure the plates exert on the air between the plates.
What special legal considerations impact : Select and describe a company whose primary means of business transacting is conducted online. What special legal considerations impact such a company when compared to one that does business locally only?
Explain changes would affect the amount of the substance : A mixture of NaCl, SiO2, and CaCO3 is separated following the procedure given in this experiment. Indicate how each of the following procedural changes would affect the amount of the specified substance recovered.
What is the instantaneous angular velocity of the disk : Starting from rest, a disk rotates about its central axis with constant angular acceleration. In 5.0 s, it rotates 45 rad. What is the instantaneous angular velocity of the disk at the end of the 5.0 s
Calculate the total energy stored in the space : A point charge is placed at the origin of the spherical system of coordinates. a) Calculate the total energy stored in the space between R=a and R=b (b>a); b) What is the energy stored between R=b and R=5b

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Use mips assembly language

Write an assembly program to calculate sum of number10 through 25

  What is the approximate rise time step response

(a) find the value of a and K so that the relative damping ratio of the system is 0.5 and the rise time step response is approximately 1 s. (b) with the values of a and k found in previous question

  Design an op-amp amplifier circuit

Design an op-amp amplifier circuit where the smallest resistor available is 10k . The circuit must yield the relationships shown in the following equation: Vout = 8v1 + 8v2 - 4va - 9vb

  Find value of the generated emf when output power given

The resistance of the field circuit of a shunt-excited dc generator is 200. When the output power of the generator is 100kW, the terminal voltage is 500V and the generated e.m.f is 525V.

  What is the time required for the capacitor voltage

A capacitor in an RC circuit with R = 5.00 ohm and C = 6.00 mF is being charged. What is the time required for the capacitor voltage to reach 86.5 percent of its steady-state value

  Determine at rated load and unity power factor

In a 50 KVA, Y connected, 440 V, 3 phase, 50 Hz alternator, the effective armature resistance is 0.25 ohms per phase. Synchronous reactance is 3.2 ohms per phase. Determine at rated load and unity power factor,

  Surface integral for jet engine

Surface integral for jet engine.  The air-gas exhaust velocity from a jet engine varies linearly from a maximum of 300 m/s at the center of the circular exhaust opening to zero at the edges. If the exhaust diameter is 1.6 m, find  thq  exhaust flow.

  Computing peak frequency deviation and carson''s rule

Calculating peak frequency deviation and Carson's rule bandwidth, A baseband signal has a frequency range from 50 Hz to 15.0 kHz. The signal is transmitted using frequency modulation. The FM transmitter has a modulation constant of 100 kHz per vol..

  Find v-high to obtain twice rated current

John's house is served electrically by a single phase transformer rated 15 kVA, 8160 / 220 V, 60 Hz. The leakage reactance of the transformer is 400 ohms referred to the high side. John wants to replicate an interesting EEE 360 experiment

  Calculate the converter voltage vc1

Calculate the converter voltage VC1, reactive power, the converter phase current and modulation index.

  Find the value of the force on q1 and q2

Two point charges, Q1 =30 C and Q2 =-100 C,are located at (2,0,5) m and (-1,0,-2) m, respectively. Find the force on Q1 and Q2.

  What is the magnitude of the induced emf per phase in rotor

A three-phase induction motor operates at a slip of 3% and has a rotor copper loss of 300W. The rotational loss is 1500W. Determine (a) The air-gap power (b) The power output (c) If the rotor impedance is 0.2+j0.8 ohm/phase,

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd