Calculate the power source at the central office

Assignment Help Electrical Engineering
Reference no: EM13255547

Suppose the voltage across a telephone line at the subscriber drops from 48V to 10V when the phone goes off hook. If the telephone instrument has a resistance of 200 ohms when off hook and represents an open circuit when on hook calculate the combined resistance of the local loop and the power source at the central office.

Reference no: EM13255547

Questions Cloud

Determine the kinetic energy : A 1.00kg mass oscillates according to the equation x=0.600cos8.50t, where x is in meters and t is in seconds. Determine the kinetic energy when x = 0.360m
Specify the range of acceptable input frequencies fm : A linear digital filter Hd(z) is given below, and the sampling rate is T=0.1 seconds. Hd(z)=(z-j)(z+j)/(z-0.5)(z+0.5) 1. Show poles and zeros of Hd(z)in the complex z plane. Is this filterstable
Explain the technique used to determine the density : Describe the technique used to determine the density of approximately 5 gram samples of the following at 20 degrees C and 1 atmosphere pressure: A) Gasoline B) Granular Sugar C) A lump of gold D) Mercury
What frequency does the cyclist hear : A burglar alarm in a house emits sound at a fixed frequency of 3.1 kHz. On a windy day a person cycles past the house while the alarm is sounding. What frequency does the cyclist hear
Calculate the power source at the central office : Suppose the voltage across a telephone line at the subscriber drops from 48V to 10V when the phone goes off hook. If the telephone instrument has a resistance of 200 ohms when off hook and represents an open circuit
Explain carbon tetrachloride and cyclohexane : Suggest simple laboratory tests you could use to distinguish acetone, carbon tetrachloride, cyclohexane, ethyl ether and ethanol.
Compute the energy in j of one photon of this radiation : An X-ray has a wavelength 1.44A. Calculate the energy in J of one photon of this radiation.
Find the potential difference between ground and sphere : A metal sphere is suspended by a silk thread and charged positively. If in carrying a positive charge of 5.0E-8 C, what is the potential difference between the ground and the sphere
Determine vaulters altitude as vaulter crosses the bar : A 52-kg pole vaulter running at 12 m/s vaults over the bar. Her speed when she is above the bar is 0.7 m/s. Neglect air resistance, as well as any energy absorbed by the pole, and determine her altitude as she crosses the bar.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the maximum power delivered to the element

v(t)=20te^( -40t ) and i(t)=50te^( -40t ) for t>=0  both v and i are zeros for i

  Define the quiescent-idle response of the circuit

The circuit will have as inputs a minimum of two inputs; the binary equivalent of two decimal numbers of not greater than (10,000)10. The circuit will also produce a minimum of two outputs, the quotient and the remainder.

  Presume the information portion of a packet contains

Suppose the information portion of a packet contains 10 bytes consisting of the 8- bit unsigned binary ASCII representation of string "Link Layer".

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Find line current and the power factor of the combined loads

Two three-phase loads are y-connected across a 300 Volt three phase line. One load draws 10kW at a p.f. of 0.9 leading, and the second load draws 8kW at a p.f. of 0.6 lagging. V(line-neutral)=300V/sqrt(3)=173.21V

  Create a bandpass filter with cutoff frequencies

Create a bandpass filter with cutoff frequencies of 100-1k, attenuate by at least 3db at desired frequency(100-1k) and at 60Hz attenuate by 10 db. Resistor, Capacitor, Inductor, and Op-amps can be used.

  Design a microstrip transmission line with z0

Design a microstrip transmission line with Z0 = 100 ohm that will be etached onto a dielectric substrate with er= 3 and a thickness of 4 mm. what should be the width of the microstrip line

  Determine the power factor for the combined load

A company has 100 metal halides (400W each with 1.2 ballast factor) and four motors (each with 50 hp capacity, 95% efficiency, 100% load factor, and 80% power factor). The power factor for the combined load

  Design a critically damped series rlc circuit

Using the commonly available resistors, capacitors, and inductors, design a critically damped series RLC circuit (i.e., all three components are connected in series) with an undamped natural frequency of 20 krad/s.

  Find the emission coefficient n

Power Electronics - Diode, [Power electronics] The measured values of a diode at a temperature of 25 Degrees Celsius are: Vd=1V at Id=50A, Vd=1.5V at Id=600A. Determine (i) the emission coefficient n, and (ii) the leakage current.

  Explain what is the name of the standard unit cell

A 3-D cubic unit cell contains four atoms whose centers are positional halfway up along each of the vertical cell edges and one atom each centered in the middle of the top and bottom faces. Make a sketch of the unit cell.

  Basic column control

The basic column control system shown in Figure is somewhat more complicated than the basic neutralizer control system

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd