Calculate the power required to drive the compressor

Assignment Help Other Subject

Reference no: EM13300262

Air compressor is used to compress 0.03 kg/s atmospheric air from 1 bar and 25oC to 10 bar. If the compression process is polytropic and follows the relation PV1.3=constant, calculate the power required to drive the compressor and the heat loss. Consider the pipe diameter at the inlet is 5 cm and that at the exit is 2 cm.

Reference no: EM13300262

Questions Cloud

Steam enters converging–diverging nozzle operating at steady : Steam enters a converging–diverging nozzle operating at steady state with P1 = 40 bar, T1 = 400oC, and a velocity of 10 m/s. The steam flows through the nozzle with negligible heat transfer and no significant change in potential energy. At the exit, ..

Calculate air velocity and mass flow rate through the slit : the room described in problem 8.1 gas a 1 m wude door with a 1 cm high slit at the floor level. THe oil spill has a rectagular area of sides 0.5 m by 0.5 m. (a) calculate the pressure increase, the air velocity, and the mass flow rate throug the sl..

What was the firm eat in 2009 : Slattery Corp had year-end retained earnings balances of $670,000 in 2008 and $600,000 in 2009. In 2009 the firm paid $6,000 in preferred dividends and $10,000 in common dividends. What was the Firm's EAT IN 2009?

Organized to focus more on organizational : As you probably have noted, this course is organized to focus more on organizational and enterprise level issues than on individual or group behavior. There are other courses in the program that allow you the opportunity to reflect on lower le..

Calculate the power required to drive the compressor : Air compressor is used to compress 0.03 kg/s atmospheric air from 1 bar and 25oC to 10 bar. If the compression process is polytropic and follows the relation PV1.3=constant, calculate the power required to drive the compressor and the heat loss. Cons..

Find appropriately sized beam such that radius is not less : The yield stress for A-36 is 250 MPa. Using factor of safety against yield of 1.25, determine an appropriately sized beam such that the radius of curvature is not less than 140m. E= 200 GPa, G= 77.2 GPa.

Calculate the wacc be determined : How should the capital structure weights used to calculate the WACC be determined?

Steam enters the nozzle of a turbine with a low velocity : Steam enters the nozzle of a turbine with a low velocity at 3 MPa, 350°C, and leaves the nozzle at 1.6 MPa at a velocity of 550 m/s. The rate of flow of steam is 0.5 kg/s. Calculate the quality or temperature of the steam leaving the nozzle and the e..

Nitrogen gas is heated in steady-state-steady-flow process : Nitrogen gas is heated in a steady-state, steady-flow process. The inlet conditions are 550 kPa, 35°C, and the exit conditions are 500 kPa, 1000°C. Kinetic and potential energy changes are negligible. Calculate the required heat transfer per kg of ni..

User Account

All Pages