Calculate the power consumed by the device at any time

Assignment Help Electrical Engineering
Reference no: EM13268446

The voltage, v, across a device and the current, i, through it are:

v(t) = 10 sin 5t V, and i(t) = 15(1-e-t/4) A

Calculate:

a) the total charge in the device at t = 3 s, assume q(0) = 0 (round to three decimal places)?

b) the power consumed by the device at t = 1 s (round to three decimal places)?

Reference no: EM13268446

Questions Cloud

Explain metal m can readily form the m+ cation : Consider a metal atom, which we will give the symbol M. Metal M can readily form the M+ cation. If the sphere on the left below represents the metal atom M, which of the other three spheres would probably represent the M+ cation? Explain your choi..
How much mass was lost in the process : When a uranium nucleus at rest breaks apart in the process known as fission in a nuclear reactor, How much mass was lost in the process
Calculate the firms new long term debt : Assume that net capital spending was zero, no new investments were made in net working capital, and no new stock was issued during the year. Calculate the firms new long term debt added during the year.
Find the equilibrium temperature : Three liquids are at temperatures of 5.0°C, 21°C, and 33°C, respectively. Equal masses of the first two liquids are mixed, Find the equilibrium temperature when equal masses of the first and third are mixed
Calculate the power consumed by the device at any time : Calculate: a) the total charge in the device at t = 3 s, assume q(0) = 0 (round to three decimal places) b) the power consumed by the device at t = 1 s (round to three decimal places)
Determine what is the angle of the middle one : Unpolarized light is incident on three polarizers: The first making an angle of 0 degrees with the vertical; the second making an angle of ? degrees with the vertical; and the last one making an angle of 90 degrees with the vertical.
Determine the temperature of the gas inside the sunspot : Consider a sunspot with measured field strength 1000 Gauss. Assume the ratio of the total brightness of the gas at the center of the sunspot, Determine the temperature of the gas inside and outside the sunspot
Who the counter-party is to a risk management derivatives : Explain who the counter-party is to a risk management derivatives contract that an insurance company would engage in and what his or her motives are to engage in the derivatives contract.
What was your total real return on investment : If the inflation rate was 4.0 percent over the past year, what was your total real return on investment?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the current through the 30 ohm resistor

A parallel circuit consists of a source and 15 ohm and 30 ohm resistors. The resistor of 15ohm draws a current of 8A. a) Find the current out of the current source. b) Find the current through the 30 ohm resistor.

  Determine the voltage range that would be converted to pcm

For a 12-bit linear PCM code with a resolution of 0.02 V, determine the voltage range that would be converted to the following PCM codes. (a) 1 0 0 0 0 0 0 0 0 0 0 1 (b) 0 0 0 0 0 0 0 0 0 0 0 0

  Define a three-phase overhead transmission line

A three-phase overhead transmission line has a per-phase resistance of 0.15 ohm/km, and a per-phase inductance of 1.3263 mH/km.

  Write down an expression for the voltage waveform

An a.c. voltage, V, comprises of a fundamental voltage of 100 V rms at a frequency of 120 Hz, a 3rd harmonic which is 20% of the fundamental, a 5th harmonic which is 10% of the fundamental and at a phase angle of 1.2

  Design a low-pass filter with a cutoff frequency

A) Design a low-pass filter with a cutoff frequency of 12 kHz. Use 0.15 uF capacitor and an appropriate resistor. B) Sketch and label the circuit. C) What is the gain of the filter at a frequency of 20 kHz Give your answer both as ratio (Vout/Vin) an..

  Design a logic circuit with 8-inputs and 4-outputs

Design a logic circuit with 8-inputs and 4-outputs. The circuit should count the number of 1's in the input. The output should be values between 0 and 8.

  Write complete ionic and net ionic equations for given eqtns

Write complete ionic and net ionic equations for each of the following molecular equations. a. 2HNO3(aq) + Mg(OH)2(s) ----- > 2H2O(l) + Mg(NO3)2(aq) Nitric acid, HNO3, is a strong electrolyte.

  Discuss the procedure for design using anthropometric data

Discuss the procedure for design using anthropometric data. Include Confidence Intervals (CIs). Select any one anthropometric measurement for males or females in Table 5.3 and find 90% CI for the mean measurement of the population.

  Write function called balloon that will accept single value

Write a function called Balloon that will accept a single variable named S. The function should replace S with the square of S and repeat this process until S is either greater than 10^15 or less than 10^-15.

  What is its energy after the current drops to zero

1) A 1.5H inductor has a constant current of 2.5A. a) find the energy that it holds b) what is its voltage c) what is its energy after its current drops to zero and stays zero What power is dissipated when a 20 olhm resistor is connected to it

  Write a program that calculates the quadratic equation

write a program that calculates the quadratic equation. the program should be able to compute imaginary numbers (i.e. sqrt(-1)). finally, output the tow result. hint: the computer cannot directly compute imaginary numbers

  Find the attendant attenuation in db

An Electromagnetic wave at 120 MHz travels through a lossy di-electric medium. At this frequency, the depth of penetration is 4 m, if the wave travels 10 m, find the attendant attenuation in dB.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd