Calculate the percent by mass of the caco3 in the sample

Assignment Help Chemistry
Reference no: EM13173995

dissolving 3.00g of impure CaCO3 in excess HCl produced .656L of CO2- measured at 20C and 782mmHg. calculate the percent by mass of the CaCO3 in the sample.

Reference no: EM13173995

Questions Cloud

Plot the process path in a p-v diagram : Helium gas is heated at constant volume from a state of 100 kPa, 300 K to 500 K. A following process expands the gas at constant pressure to four times the initial volume.
Concentration of titanium in the original unknown solution : As a reference, a standard mixture containing 2.26 micrograms Co/mL and 1.92 micrograms Ti/mL was prepared and measured to have a signal-to-signal ratio of 2.41 Ti: 1.00 Co.
Determine the m&o costs for alternative s : Alternative S has a first cost of $175,000 and a $40,000 salvage value after 5 years, but its annual M&O costs are not known.
Calculate if the cycle were traversed in opposite direction : It is then restored to its original state by the extraction of heat at constant pressure. Calculate w for each step and for the total process. What values for w would you calculate if the cycle were traversed in the opposite direction?
Calculate the percent by mass of the caco3 in the sample : dissolving 3.00g of impure CaCO3 in excess HCl produced .656L of CO2- measured at 20C and 782mmHg. calculate the percent by mass of the CaCO3 in the sample.
State the rock sample and the associated uncertainty : Type your question hereA 0.1390-g rock sample of unknown concentration was dissolved in HCl and diluted to 100.0 mL. Aliquots of 10.00 mL of this unknown solution were added to different volumes
What is the activation energy for the uncatalyzed reverse : What is the activation energy for the uncatalyzed reverse reaction?
Why vanderwaals equation of state is not well defined : why vanderwaals equation of state is not well defined in 1 dimension. and what is ratio of critical constants in 2 dimension and 3 dimension.
State electrolytic cell that contains a molten : How many grams of thallium may be formed by the passage of 57.5 amps for 1.34 hours through an electrolytic cell that contains a molten

Reviews

Write a Review

Chemistry Questions & Answers

  Calculate the diffusion limiting current for the oxidation

Calculate the diffusion limiting current for the oxidation of an organic compound at an electrode in stagnant solution. Assume 6 electrons are involved in the reaction (n=6). C(org) = 0.01 M, D(org) = 2x10^-5 cm^2/s.

  What fraction of the time will the current be turned on

An oil bath maintained at 50.5 oC loses heat to its surroundings at the rate of 4.68 kJ/min. Its temperature is maintained by an electrically heated coil with a resistance of 60 operated from a 110 V line.

  Explain how many mmoles of mercury are in the sample

How many mmoles of mercury are in the sample? B) How many mg's of mercury are in the sample? C)What is the percent mercury (w/w) in the ointment?

  Calculating the amount of n2 gas released

The solubility of N2 in blood at 37°C and at a partial pressure of 0.80 atm is 5.6 10-4 mol/L. A deep-sea diver breathes compressed air with the partial pressure of N2 equal to 3.6 atm.

  What is the ph of the solution

A 10.00 mL 0.25 M formic acid sample is being titrated with 0.25 M NaOH. What is the pH of the solution after adding 15.00 mL NaOH solution?? Ka=1.8x10-4

  Define how many seconds after the start of the reaction

How many seconds after the start of the reaction does it take for the reactant concentration to decrease to 0.0185 M?

  State what is the enthalpy change of methyl alcohol

What is the enthalpy change (in kJ) for burning 73.0 g of methyl alcohol? 2)A reaction that is used to propel rockets is N2O4(l) + 2N2H4(l) --> 3N2(g) + 4H2O(g)

  Evaluate the ph during the titration

Calculate the pH during the titration of 100.0 mL of 0.200 M HCl with 0.400 M NaOH. First what is the initial pH (before any NaOH is added

  Compute and plot the points

Calculate and plot the points where 0.00, 5.00, 10.00, 20.00, 25.00, 30.00, 35.00, 40.00, 45.00, and 50.00 mL of 0.075M KOH has been added

  Write down the empirical formula

Write down the Empirical Formula if aA Compound Is 21.20% nitrogen, 6.06% Hydrogen, 24.30% sulfur , And 48.45% Oxygen?

  How much heat is produced in kcal

If you a litre (1000mL) bottle of oil in your engine, how much heat is produced in kcal?In BTU To solve this problem you must know the density of motor oil is .82 g/mL.

  What is the partial pressure of the nitrogen gas

A mixture of O2, CO2, and N2 has a total pressure of 762. torr. In this mixture the partial pressure of O2 is 112. torr and the partial pressure of CO2 is 185. torr. What is the partial pressure of the N2 (in torr)?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd