Reference no: EM131075467
Page 355 problems 3, 4, 6, 12
3.Show the framing of the letter ASCII ‘Z' (0101 1010), no parity, 1 stop bit.
4.If there is no data transfer and the line is high, it is called ____ (mark, space).
6. Calculate the overhead percentage if the data size is 7, 1 stop bit, no parity.
12. State the absolute minimum number of signals needed to transfer data between two PCs connected serially. Give their names.
Page 529 problems 1-5
1.True or false. The SPI protocol writes and reads information in 8-bit chunks.
2.True or false. In SPI, the address is immediately followed by the data.
3.True or false. In an SPI write cycle, bit A7 of the address is LOW.
4.True or false. In an SPI write, the LSB goes in first.
5.State the difference between the single-byte and burst modes in terms of the CE signal.
Page 535 problems 1-4
1.True or false. In the HCS12, we have at least two sets of SPI modules.
2.True or false. The SPIxBR register is used for setting SCLK speed.
3.True or false. In the HCS12, the highest SCLK is BusFreq/2.
4.True or false. In transferring data, the use of SPISR is optional.
|
An adc with eight channels of analog input
: 1. True or false. Sensor output is in analog. 5. True or false. An ADC with 8 channels of analog input must have 8 pins, one for each analog input.
|
|
Derive the equation for motion of the object
: Derive the equation for motion of the object starting from the force equation. Show each step and find the time at which it reaches ground and it's speed when it hits the ground.
|
|
Find the general solution of the linear system
: Find the general solution of the linear system corresponding to the following augmented matrix
|
|
Find the spring potential energy
: Find the spring potential energy, the kinetic energy of the block, and the total mechanical energy of the system, for compressions of 0. Find the spring potential energy, the kinetic energy of the block, and the total mechanical energy of the sys..
|
|
Calculate the overhead percentage
: 3.Show the framing of the letter ASCII ‘Z' (0101 1010), no parity, 1 stop bit. 4.If there is no data transfer and the line is high, it is called ____ (mark, space).
|
|
Sketch both the original triangle and its image
: Sketch both the original triangle and its image.
|
|
Treat the masses on the ends
: What is the magnitude of the angular momentum of the system taking the center of the rod as the origin? Treat the masses on the ends as point masses.
|
|
Encounters a spring with a force constant
: A 1.00kg block slides with a speed of 0.880m/son a frictionless horizontal surface until it encounters a spring with a force constant of 450N/m . The block comes to rest after compressing the spring 4.15 cm.
|
|
Construct simple novel visualization of choosen architecture
: Choose an architecture modeling notation and construct a simple novel visualization for it. For example, develop a simplified graphical editor that focuses only on a few kinds of elements
|