Calculate the overall speedup of a system

Assignment Help Basic Computer Science
Reference no: EM13314345

1. How is a Network Layer protocol different from a Transport Layer protocol?

2. Into which Class of networks do the following IP Addresses fall?

a.) 180.265.14.3

b) 218.193.149.222

c) 92.146.292.7

3. Into which class of networks do the following IP addresses fall?

a.) 223.52.176.62

b.)127.255.255.2

c.) 191.57.229.163

4. Calculate the overall speedup of a system that spends 65% of its time on I/O with a disk upgrade that provides for 50% greater throughput.

5. Calculate the overall speedup of a system that spends 40% of its time in calculations with a processor upgrade that provides for 100% greater throughput.

6. Amdahl's Law is as applicable to software as it is to hardware. An oft-cited programming truism states that a program spends 90% of its time executing 10% of its code. Thus, tuning a small amount of program code can often time have an enormous effect on the overall performance of a software product. Determine the overall system speed up if:

a. 90% of a program is made to run 10 times as fast (900% faster)

b. 80% of a program is made to run 20% faster.

7. Suppose a disk has the following characteristics

- 4 Surfaces
-1024 Tracks per surface
-128 Sectors per track
-512 bytes/sector
-Track-to-track seek time of 5 milliseconds
-Rotational speed of 500 RPM

a. What is the capacity of the drive?

b. What is the access time?

8. Suppose a disk has the following characteristics

- 5 Surfaces
-1024 Tracks per surface
-256 Sectors per track
-512 bytes/sector
-Track-to-track seek time of 8 milliseconds
-Rotational speed of 7500 RPM

a. What is the capacity of the drive?

b. What is the access time?

9. Suppose a disk has the following characteristics

- 6 Surfaces
-16,383 Tracks per surface
-63 Sectors per track
-512 bytes/sector
-Track-to-track seek time of 8.5 milliseconds
-Rotational speed of 7200 RPM

a. What is the capacity of the drive?

b. What is the access time?

Reference no: EM13314345

Questions Cloud

How long will take the water in the aquifer to travel 100ft : A truck spils 1 gallon of benzene into an aquifer with an area= 50ft^2 Benzene has a solubility of 1750 ppm, and a specific gravity of 0.873. The aquifer ahs a porosity of 0.25, a hydraulic gradient of 0.004 and a hydraulic conductivity of 1000 gp..
Prepare the journal entry for current tax : Calculate taxable income and prepare the journal entry for current tax payable (the tax rate is 30%) as at 30th June 2014 and using the direct method, prepare the Cash flows from Operating Activities.
How much atrizine must be removed per day to comply : Waste water is dischared into a aquifer. This waste water contains 0.1 ppm atrazine (a common herbicide). The MCL of atrazine is 5 ppb, the density is 1.19 g/ML and the solubility is 50 ppm.
Explain what volume is occupied by 1.00kg of oxygen gas : what volume is occupied by 1.00kg of oxygen gas at 5.00 degrees Celsius at a pressure of 735 torr
Calculate the overall speedup of a system : Calculate the overall speedup of a system that spends 65% of its time on I/O with a disk upgrade that provides for 50% greater throughput.
Explain how to calculate the mcl for the acceptable risk : the water is pumped out of the aquifer at a rate of 2000 gpd, treat it with activated carbon and then put it back into the aquifer. At the flow rate how long until al the PCE is removed, assume carbon removed 100% of the PCE
Determine the speed of the arrow after traveling from rest : A bowstring produces a force against a 2.0 oz arrow given by where a = 40 lbf, b = 3.2 ft-1 and x is in ft. x = 0 when the arrow is pulled fully back and increases as the arrow moves forward.
What input of power rating is required for pump to refill : A water storage tank located on a larege dairy farm has a storage capacity of 0.1 ML. The average rate of water consumption from this tank is 6.25 kL per day, every day. The farmer refills the tank (overnight) every 14 days
What maximum force can this person apply with the jack : A person of mass 80kg places all their weight on the pedal of a foot operated hydraulic jack. The diameter of the hydraulic cylinder under foot pedal is 4cm and the diameter of the jack cyclinder is 9cm (Assume g is 9.81 m/s^2)

Reviews

Write a Review

Basic Computer Science Questions & Answers

  Identifies the cost of computer

identifies the cost of computer components to configure a computer system (including all peripheral devices where needed) for use in one of the following four situations:

  Input devices

Compare how the gestures data is generated and represented for interpretation in each of the following input devices. In your comparison, consider the data formats (radio waves, electrical signal, sound, etc.), device drivers, operating systems suppo..

  Cores on computer systems

Assignment : Cores on Computer Systems:  Differentiate between multiprocessor systems and many-core systems in terms of power efficiency, cost benefit analysis, instructions processing efficiency, and packaging form factors.

  Prepare an annual budget in an excel spreadsheet

Prepare working solutions in Excel that will manage the annual budget

  Write a research paper in relation to a software design

Research paper in relation to a Software Design related topic

  Describe the forest, domain, ou, and trust configuration

Describe the forest, domain, OU, and trust configuration for Bluesky. Include a chart or diagram of the current configuration. Currently Bluesky has a single domain and default OU structure.

  Construct a truth table for the boolean expression

Construct a truth table for the Boolean expressions ABC + A'B'C' ABC + AB'C' + A'B'C' A(BC' + B'C)

  Evaluate the cost of materials

Evaluate the cost of materials

  The marie simulator

Depending on how comfortable you are with using the MARIE simulator after reading

  What is the main advantage of using master pages

What is the main advantage of using master pages. Explain the purpose and advantage of using styles.

  Describe the three fundamental models of distributed systems

Explain the two approaches to packet delivery by the network layer in Distributed Systems. Describe the three fundamental models of Distributed Systems

  Distinguish between caching and buffering

Distinguish between caching and buffering The failure model defines the ways in which failure may occur in order to provide an understanding of the effects of failure. Give one type of failure with a brief description of the failure

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd