Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Calculate the overall efficiency, the heat rate [MW], and the total fuel rate [kg/s] of a combined-cycle power plant (1) if no supplemental firing is used and (2) if 30% of the gas turbine fuel demand is additionally burned in the supplementary firing of the HRSG. The gas turbine plant and steam turbine plant thermal efficiencies are 37.5% and 26% [both based on lower heating value (LHV)], respectively. Assume that the combined-cycle power plant has an electrical power output of 380 MW and that the fuel HFO No.2 has the lower heating value of 43 MJ/kg.
What load P allow can be supported at the midpoint of the bar if the yield stress in the steel wires is 220 MPa and in the aluminium wire is 80 MPa? A saftey factor of n = 2 is needed.
Design a high pressure homogenizer for the manufacture of 10^6 kg per year of salad dressing.
car a is traveling at va130kmh as it passes a police officer in car p but over the next 5 seconds the car uniformly
A 0.7-lb block rests on top of a 0.5-lb block supported by but not attached to a spring of constant 9 lb/ft. The upper block is suddenly removed. Determine (a) the Maximum velocity reached by the 0.5-lb block, (b) the maximum height reached by the..
a cylinder of metal that is originally 100mm tall and 50mm in diameter must be open die forged to a height if 50mm. the
if you find another software easier to do fea in then go ahead and use that instead we are just interested in the
A steel tape is used to measure a distance of 20 m at a 10 0C. Assuming that the tape will measure the true distance when the temperature is 20 0C. What would be the indicated distance at 10 0C? What would be the indicated distance at 400C?
question 1 bending about two axesthe load p 2 kn is applied to the end of rectangular section cantilever beam shown
the elevator e has a mass of 500kg and the counterweight at a has a mass of 150kg. if the motor supplies a constant
if p 400 and the coefficient of kinetic friction between the 50- crate and the inclined plane is 0.25 determine the
design a container using differentiation that has a volume of 2500 litres. it must use the minimum amount of material.
a large vessel had experienced an internal leak of a coolant. it was friday and the work crew needed to get the vessel
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd