Calculate the normal force n exerted by the side of the slot

Assignment Help Civil Engineering

Reference no: EM13555167

The flat circular disk rotates about a vertical axis through O with a slowly increasing angular velocity ?. Prior to rotation, each of the 0.60-kg sliding blocks has the position x = 29 mm with no force in its attached spring. Each spring has a stiffness of 390 N/m. Determine the value of x for each spring for a steady speed of 219 rev/min. Also calculate the normal force N exerted by the side of the slot on the block. The force N is positive if it pushes from the side labeled A. Neglect any friction between the blocks and the slots, and neglect the mass of the springs. (Hint: Sum forces along and normal to the slot.)

Reference no: EM13555167

Questions Cloud

What is the alkalinity of this water expressed as mg/l : A water sample contains 118mg/L of bicarbonate ion, 19mg/L of carbonate ion, and has a pH of 9.5. What is the alkalinity of this water expressed as mg/L of CaCO3?

What is a chance that a driver who has a positive breathalyz : A police officer stops a speeding driver on saturday nigt and gives hima breathalzer test. the test shows that his estimated blood alcohol content is above .08 g/dl, and this is considered evidence of driving while intoxicated

Do you think the gravel will be scoured by the flowing water : The bottom is a 6 in slab of rough concrete. If the water is flowing at a uniform depth of 6 ft, do you think the gravel will be scoured by the flowing water

Determine the force exerted on th mass in the direction : A 150 kg mass is suspended by wires from two hooks. the lengths of the wires have been adjusted so that the wires are each 50º from horizontal. assume that the mass of the wires is negligible.

Calculate the normal force n exerted by the side of the slot : The flat circular disk rotates about a vertical axis through O with a slowly increasing angular velocity ?. Prior to rotation, each of the 0.60-kg sliding blocks has the position x = 29 mm with no force in its attached spring. Each spring has a stiff..

Determine the shear stress at each wall and the maximum : Sketch and identify the Tresca (maximum shear stress) and von Mises (maximum distortion energy) failure criteria in two-dimensional principal stress space (i.e., ?2 vs. ?1) for the above material.

What are the northing and easting coordinates for station b : The coordinates for station A are 1023.34 N and 988.56 E. What are the northing and easting coordinates for station B that is located 40 feet due east of A, and 22.32 feet due south of A

Find the maximum allowable tensile force : A 4-cm- diameter rod of aluminum 7075-T6 is to subjected to an axial tensile force such that the factor of safety based on the yield stress on 1.75. Find the maximum allowable tensile force. The yield stress of the aluminum 7075-T6 is o-y= 500MPa.

Use the doubling time approximation to estimate : Use the doubling time approximation (3.5) to estimate the exponential rate of growth that would produce those numbers. Use the exponential growth equation (3.6) to find the growth rate

User Account

All Pages