Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 220 V shunt motor has armature and field resistances of 0.2Ω and 220Ω respectively. The motor is driving constant load torque and running at 1000 rpm drawing 10 A current from the supply.
Calculate the new speed and armature current if an external armature resistance of value 5Ω is inserted in the armature circuit. Neglect armature reaction and saturation.
Point charges Q1 and Q2 are respectively located at (4,0,-3) and (2,0,1). If Q2 = 4 nC, find Q1 such that (a) The E at (5,0,6) has no z-component (b) The force on a test charge at (5,0,6) has no x-component.
The 741 op amp is usually modeled on specification sheets as a voltage amplifier having the following parameters: Rin = 1 M, Av = 100,000, and Rout = 100 Using this information, develop equivalent circuits for the 741 as a current amplifier
It is commonly found that if a capacitor is changed to some dcvoltage and then removed from the circuit and is totally dischargedwith a "short" placed across it when the short is removed thecapacitor will slowly begin to "aquire" a small voltage.
A plane circular disk of radius 0.25m rotates at a speed of 200 rad/s about an axis through the center of the disk perpendicular to the plane of the disk. There is a uniform magnetic flux B = 1 Tesla parallel to the axis of rotation.
consider a signal xt 10 cos2pifct 4 cos 2pifmt. assume frequency modulation. the message frequency fm 23 khz.
a number of students are answering a questionnaire form that has 55 questions. answer to each question is given as an
An Al0.3Ga0.7As p-n junction LED with doping level ND = 1 x 10^18 cm-3 on n-side and NA=1x10^15 cm-3 on p-side has Vf = 0.9 V forward bias across its junction. The LED cross-section is 200 µm x 200 µm.
Design a summing amplifier that produces an output Vout = (5/2)V1+(5/3)V2 - 4V3 . Draw the complete schematic and pick the appropriate component values. The smallest resistor in the circuit should be R
any noise will pass straight through to the ADC subsystem, introducing measurement error. You have two choices to mitigate this: SW filtering and HW filtering. Either way around, you need a HW anti-aliasing (low pass) filter following the output.
b. If the opamp is configured as a non inverting amplifier with voltage gain of 100, what bandwidth will the circuit have c. With the same configuration (gain of 100), what is the maximum input for linear operation (limited by VCC)
Suppose the voltage divider circuit P3.19(a) is connected to the voltage divider shown in circuit P3.19(b), i.e., a is connected to a' and b is connected to b'. Find vo.
A series circuit has a 9V voltage source with 1 k-ohm internal resistance. Fixed resistors in the circuit provide, 200-ohm and 400-ohm resistance, respectively. To what resistance should a 300-ohm potentiometer be adjusted
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd