Calculate the minimum length of this curve

Reference no: EM13559287

The vertical curve passes over an existing underground waterline that runs perpendicular to the roadway at station 20+91.00. The top of the waterline is at elevation 407.50 feet. The minimum clearance between the roadway and the waterline must be 6 feet. The PVI is located at station 19+00.00 with elevation 420.50 feet. The design speed of the curve is 55 mph, g1 is +3%, and g2 is -3.0%. PRT= 2.5 sec, 0.35 = friction factor.

a. Calculate the minimum length of this curve.

b. Determine if the clearance between the vertical curve and the waterline is adequate.

c. If the clearance is not adequate in this type of case what modification to L would be required to increase the clearance? Discuss possible ramifications of making this modification. (Do not need to do any calculations in part c).

Reference no: EM13559287

Questions Cloud

What is the mean momentum flow rate down the pipe : Provided that the amplitude is sufficiently great, the human ear can respond to longitudinal waves over a range of frequencies from about 20 Hz to about 20000Hz. Compute the wavelength corresponding to these frequencies a.) for waves in air ( v= 344 ..

Determine the intensities w1 and w2 of the distributed load : Which two-dimensional point lattice corresponds to the cyrstalline ceramic illustrated in Figure 1.8(a) of the text book. Provide a sketch of the unit cell

Determine the factored uniformly distributed loads per foot : A structural steel beam supports a roof that weighs 20 psf. An analysis of the loads has the following: S=12 psf, L_r=18 psf and W=38 psf (upwards) or 16 psf (downwards). If the beams are spaced 6ft 0 in apart

Find the mole fraction and mass fraction of each component : A gaseous mixture of carbon monoxide, carbon dioxide, methane and nitrogen gas is analyzed with a gas chromatograph (GC). The output takes the form of a series of peaks where each peak corresponds to a component and a peak area (A) is proportional to..

Calculate the minimum length of this curve : If the clearance is not adequate in this type of case what modification to L would be required to increase the clearance? Discuss possible ramifications of making this modification. (Do not need to do any calculations in part c).

What would the height of a water tower with a 500 gallon : What would the height of a water tower with a 500 gallon tank have to be, to bring water ( by gravity ) from sealevel over a distance of 2.5miles with an elevation of 300ft?

What is the magnitude of the force required at the bottom of : The 1.5m2 pub sign hanging outside The Drunken Engineer, weighs 200N and is hinged along its top edge. Determine the deflection in degrees for horizontal wind speed of 10m/s and what is the magnitude of the force required at the bottom of the sign to..

Find through what distance does the piston drop : Suppose a monatomic ideal gas is contained within a verticalcylinder that is fitted with a movable piston. find Through what distance does the piston drop

Determine the inside heat transfer coefficient : The specific heat capacity Cp of the process fluid is not known at the mean bulk fluid temperature but is a linear function of temperature, and must be calculated using the following information, Cp at 300K is 1.98 kJ/kgK, and Cp at 400K is 2.65 kJ/k..

User Account

All Pages