Calculate the maximum value of the work function

Reference no: EM13712763

Question- Assume that most of the electromagnetic energy from the sun is the visible region near 500 nm. Calculate the maximum value of the work function for a metal to be used in photovoltaic cells to convert solar energy into electicity.

Then identify which of the following metals could be used in such a capacity:

• silver (phi) = 7.59 x 10-19 J

• silicon (phi) = 7.24 x 10-19 J

• tungsten (phi) = 7.20 x 10-19 J

• titanium (phi) = 6.94 x 10-19 J

• barium (phi) = 4.29 x 10-19 J

• potassium (phi) = 3.78 x 10-19 J

I need proficient help to solve the above problem

Reference no: EM13712763

Questions Cloud

Describe bearing failure analysis : 1. What factors must be considered when selecting rivet layout, size and material? 2. Describe the basic types of rivet failure modes. 3. Describe bearing failure analysis.

Planners of an experiment are evaluating the design : Planners of an experiment are evaluating the design of a sphere of radius R that is to be filled with helium (0°C, 1 atm pressure). Ultrathin silver foil of thickness T will be used to make the sphere, and the designers claim that the mass of ..

What is the density of an aqueous solution of potassium : What is the density of an aqueous solution of potassium nitrate that has a normal boiling point of 103.0 degree C and an osmotic pressure of 122 atm at 25 degree C

Restitution between the two blocks is e = 0.8, determine : Block B of mass 2 kg is attached to an unstretched spring of stiffness k = 10 kN/m and is at rest on a horizontal frictionless surface. Block A of mass 4 kg moves at a velocity of uA = 10 m/s and strikes block B. If the coefficient of restitut..

Calculate the maximum value of the work function : Assume that most of the electromagnetic energy from the sun is the visible region near 500 nm. Calculate the maximum value of the work function for a metal to be used in photovoltaic cells to convert solar energy into electicity.

What is the mole fraction of water : The molality of the solution is 8.51m. If 2.00 mLs of this solution is transferred to a 500 mL volumetric flask and diluted to volume with water, what is the percent A by weight, the ppm A, and the molarity of the solution. What is the mole fracti..

The board will be in a horizontal position : A sturdy 2.44m board is to be used to raise one corner of an automobile to remove a tire. If that corner of the car weighs about 2000N and the pivot under the board can be no closer than 20.0cm from the end of the board supporting the car, calc..

Ethyl iodide decomposes at a certain temperature : Question- Ethyl iodide (C2H3I) decomposes at a certain temperature in the gas phase as shown in the following equation. C2H3I(g) C2H4(g) + HI(g) From the following data determine the rate constant.

The speed of the bullet just before it hit the block : In a police ballistics test, a 2.00-g bullet suddenly hits and becomes embedded in a 5.00-kg wood block which is hanging from a 1.60-m long string. This causes the block to swing through an arc of 5.50°. What was the speed of the bullet just b..

User Account

All Pages