Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
How do I solve this problem, a 1/4 in diameter rod must be machined on a lathe to a smaller diameter for use as a specimen in a tension test. The rod material is expected to break at a normal stress of 63750 psi. If the tensil testing machine can apply no more than 925 lbs. of force to the specimen, calculate the maximum rod diameter that should be used. (precision 0.000)?
The boat is travelling along a circular path with a speed v=(0.0625t). Determine the magnitude of its acceleration when t=10s
We would continue embankment work even if winter season and my question is what is swelling amount of compacted soil for 30cm thickness and 95% compaction degree by freezing.
Water with a static pressure of 1.96kN/M2 flows through an 800 mm diameter pipe. A pitot tube pressure gage in this pipe reads a pressure of 5.88 kN/M2. How do you determine the volume flow rate (Q) of the water? (Q = 1.40 M^3/sec, V=2.79 M/sec)
Compute the maximum acceptable tensile service load T that may act on a single angle L6x4x3/4 that is welded along only one leg to a gusset plate; thus, there are no holes. The service load is three times the dead load. Solve for a0 A36 steel.
Describe some of the benefits of physical models and mock-ups. What data are required to measure the following cost-effectiveness, system effectiveness, operational availability, and life-cycle cost?
Write the unit of measurement and unit of payment of following items. 1) Earthwork in excavation in foundation. 2) Framwork. 3) Steelwork in trusses. 4) Damp proof course D.P.C. 5) Cement.
When P = 800 lb, A) Draw the shear and bending moment diagram along its length; B) Determine the maximum tensile and compressive bending stresses; and C) determine the maximum shear stress.
What additional data and information should he gather,and how should he go about gathering the data information ?
what is the final dissolved oxygen concentration (in mg/L) in the waste lagoon after all of the ammonium (NH4 + ) is converted to nitrate? Recall that 4.57 mg of O 2 is need per mg of ammonium (as N) oxidized during nitirification. After all of the..
Determine: a) the height of the water, with respect to the base of each standpipe, and b) the effective stress at the depth of each standpipe, at the following times:
The total flow then moves to a point W on the traction drive two metres off the ground, and travels through a nine millimetre diameter conduit. Ignoring all friction and minor losses, determine the pressures at points H and W.
Calculate the force (in Kn) a punch press must exert if it is to punch out a large washer from a strip of 5-mm thick sheet steel with an ultimate shear strength of 400 MPa. The washer dimensions are as follows: hole diameter is 27 mm. outside diam..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd