Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The magnetic circuit of Fig. P.2.14 has a magnetic core of relative permeability 1600 and is wound with a coil of 1500 turns excited with sinusoidal ac voltage, as shown. Calculate the maximum flux density of the core and the peak value of the exciting current. What is the peak value of the energy stored in the magnetic system and what percentage of it resides in the air-gap?
Design a CMOS Differential pair amplifier with a low frequency gain of at least 30dB, while driving a resistive load 50 ohm. The available circuit components are NMOS transistor, PMOS transistor, resistors, capacitors and inductors.
along the direction of the thumb according to the right hand rule
Using AND and OR gates, design a circuit to gate a single data input to one of four output lines, determined by the binary-encoded index on the two control lines. Which of the following did you design: decoder, demultiplexer, or multiplexer
A toroid is fille with liquid oxygen that has a magnetic susceptibility of 4*10^-3. The toroid has 2000 turns and carries a current of 15 A. Its mean radius is 20 cm, and the radius of its cross section is 8 mm. (a) What is the magnetization
(b) Verify that there are 4.994×(10 to the power 22) atoms per cubic centimeter in the Si lattice at room temperature. (c) Determine the center to center distance between nearest neighbours in the Si lattice.
A three-bit Johnson counter is clocked with pulses at a 120 MHz rate. What will be the pulse frequency of the output of the last flip-flop in the chain. Ten pulses are applied to a four-bit asynchronous counter. If the counter state was 0000 befor..
Given the impedance of each element in rectangular form, write a program to determine the total impedance in rectangular form of any number of series elements.
A three-phase induction motor is required to operate from a single-phase source. One possible connection is shown in Figure P18.28. Will the motor work? Explain why or why not.
A differential amplifier has a bias current of 100 n A, a maximum offset current of 20 n A, a maximum offset voltage of 2 mV, an input resistance of 1 MΩ, and a differential gain of 1000. The input terminals are tied to ground through (exactly equ..
Explain the Configurations and Characteristics Of Distribution Substations with Figures showing small, medium, and large substations .
1.How is crude oil formed ?How is it found/discovered ? 2.How is natural gas formed? (Start with plankton) and include crude oil formation.
Supposed that at t=0, we connect an uncharged 10μF capacitor to a charging circuit consisting of a 2500V voltage source in series with a 2MΩ resistance. At t=40s, the capacitor is disconnected from the charging circuit and connected in parallel wi..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd