Calculate the maximum dynamic error of the sensor

Assignment Help Electrical Engineering

Reference no: EM13226418

The dynamic error is defined as the error measured by a sensor when driven by an input signal at a particular frequency. An underdamped sensor with a static sensitivity of K=1, undamped natural frequency of omega=1400 rad/s, and damping ratio of zeta=0.5 is used to measure a sinusoidal signal with a frequency of 6 kHz. Calculate the maximum dynamic error of the sensor.

Reference no: EM13226418

Questions Cloud

Determine the change in the regulated output voltage : A shunt regulator utilizing a zener diode is biased on through a 100 resistor. Determine the change in the regulated output voltage for the two situations below: a) VI changes +2.0 V, ILoad constant b) ILoad changes +100 mA, VI constan..

Explain what is ksp for the compound : The solubility of an ionic compound M2X3 (molar mass = 200. g) is 2.3 multiplied by 10-17 g/L. What is Ksp for the compound?

Explain reaction occurs and equilibrium is established : A mixture initially contains A,B, and C in the following concentrations: A= 0.650 M, B= 0.800M , and C= 0.550M . The following reaction occurs and equilibrium is established

What information can aid the ability of a manager : what information can aid the ability of a manager to correctly identify areas that require improvement or could benefit from improvement in future planning for the business? explain why this information should be considered.

Calculate the maximum dynamic error of the sensor : An underdamped sensor with a static sensitivity of K=1, undamped natural frequency of omega=1400 rad/s, and damping ratio of zeta=0.5 is used to measure a sinusoidal signal with a frequency of 6 kHz.

What information can be sought and gained to monitor : what information can be sought and gained to monitor effectiveness of any continuous improvement efforts?

Explain how a manager can be a positive role model for staff : explain how a manager can be a positive role model for staff within a business. detail the qualities a manager should possess.

Design a voltage-divider network to supply the load : The voltage across the load must remain between 4.7 and 5.0 V for all values of load current. Design a voltage-divider network to supply the load. You may assume that resistors of any value desired are available.

State the excess oxygen produce carbon dioxide and water : How many molecules of carbon dioxide are produced when 121 molecules of acetylene (HCCH) to react in excess oxygen produce carbon dioxide and water?

User Account

All Pages