Calculate the maximum diameter of the cylinder tank

Assignment Help Electrical Engineering
Reference no: EM13276125

The strength of longitudinal joint in Fig. 1-17 is 33 kips/ft, whereas for the girth is 16 kips/ft. Calculate the maximum diameter of the cylinder tank if the internal pressure is 150 psi.

Reference no: EM13276125

Questions Cloud

Obtain the change in entropy in universe : A one kilogram textbook drops from a one-meter high table in a room at 250C temperature.  Find the change in entropy after the system has reached equilibrium
Determine required diameter if the stress is not to exceed : A steel wire 30 ft long, hanging vertically, supports a load of 500 lb. Neglecting the weight of the wire, determine the required diameter if the stress is not to exceed 20 ksi and the total elongation is not to exceed 0.20 in. Assume E = 29 × 106..
Explain 2-dibenzoylethylene in ethanol : The balanced equation for trans-1,2-dibenzoylethylene in ethanol to give the product cis-1,2-dibenzoylethylene
Explain first order decomposition in which the rate constant : In a first order decomposition in which the rate constant is 0.201 sec-1, how long will it take (in seconds) until 0.131 mol/L of the compound is left, if there was 0.566 mol/L at the start
Calculate the maximum diameter of the cylinder tank : The strength of longitudinal joint in Fig. 1-17 is 33 kips/ft, whereas for the girth is 16 kips/ft. Calculate the maximum diameter of the cylinder tank if the internal pressure is 150 psi.
Find the maximum height to which the tank may be filled : A water tank, 22 ft in diameter, is made from steel plates that are ½ in. thick. Find the maximum height to which the tank may be filled if the circumferential stress is limited to 6000 psi. The specific weight of water is 62.4 lb/ft.
Explain what statement below best describes the graph : What statement below best describes the graph representing the integrated 1st order rate law plot of ln[a] vs t having a straight line negative slope equal to -k
What is the energy difference between the hyperfine levels : Radio astronomers often study the radiation emitted by a hydrogen atom from a transition between the two hyperfine levels associated with the ground state
Operating systems that can be used in health care delivery : What benefits does one provide over the other and what pitfalls must the professional be aware of?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the range of frequencies generated by oscillator

Consider a superheterodyne FM receiver designed to receive the frequency band of 1 to 20 MHz with an IF frequency 8 MHz. what is the range of frequencies generated by the local oscillator for this receiver

  How many sec are required for system to reach steady state

a. if the input r(t)=5u(t), ie. R(s)=5/s, find the steady-state of C(t), b. Approximately how many seconds are required for the system to reach steady state note you two time constants to consider, and c. Do you expect the transient response to be o..

  Find the sample space for the experiment

Find the sample space for the following experiment: Drawing bolts from a lot of 20, containing one defective D, until D is drawn, one at a time and assuming sampling without replacement, that is, bolts drawn are not returned to the lot.

  Explain what determines which region the transistor is in

What is the difference between the saturation and active regions of a BJT. What determines which region the transistor is in.

  Find value of the capacitor connected in parallel with load

120V, 60 Hz source is connected to a distribution line whose resistance, and inductive reactances are 0.1Ohm, j0.2 Ohm, respectively. Single phase, 2HP, 120V, 0.75 lagging pf. motor and 2.4Kw, 120V heater is connected in parallel.

  Design a combinational logic circuit which has one output z

Design a combinational logic circuit which has one output Z and a 4-bit input ABCD representing a binary number. Z should be 1 iff the input is at least 5, but is no greater than 11. Use one OR gate (three inputs) and three AND gates

  Find capacitive susceptance per km of single-phase line

Find the capacitive susceptance per km of a single-phase line operating at 60Hz, using both the capacitance formula and the Tables. The conductor is Partridge, and spacing is 20ft between centres.

  What is the largest data that can be carried into the cpu

A given computer has a 32-bit data bus. What is the largest data (in decimal) that can be carried into the CPU at a time 13.In a given byte-addressable computer, memory location 10000H-9FFFFH are available for user programs.

  How big will be rms value of voltage across coil nd resistor

how big will be inductance of coil if it is connected in series with resistor 30 omega on AC circuit with input voltage with RMS value U1=(220+2*1.7) V and frequency 50 Hz if power factor of the circuit is 0.6

  Calculate the approximate value of the synchronous reactance

A 150MW alternator generates an open-circut line-t0-line voltage of 12kV at nomial DC excitiation. When the terminals are placed in short-circuit the resulting current per phase is 8000A.

  Find the force acting on the craft and maximum acceleration

For a "Personal water craft" water is pumped from beneath the craft and discharged out the rear in a 1.25 inch diameter stream at a velocity of 75 ft/sec. Assuming that the craft and rider weighs 650lbs find the force acting on the craft and maxim..

  Draw a state diagram for a clocked synchronous state machine

Once INIT is negated, Z should remain 0 until X has been 0 for two successive ticks and 1 for two successive ticks, regardless of the order of occurrence. Then Z should go to 1 and remain 1 until INIT is asserted again.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd