Calculate the mass flux rate and the flow rate

Assignment Help Civil Engineering
Reference no: EM13552747

1.A line was measured five times, the readings were: 100.08, 100.51, 100.32, 100.16, 100.22. what is the error? What is the most probable length?

2.Currently, the submarine shown has an empty ballast tank. In order to submerge to a depth of 50 feet from its present depth, how much sea water (in cubic feet) must be taken in? Assume specific gravity of 1.03 for sea water and sub is 300 feet long.

3.Water is flowing in a 6-cm diameter pipe at 20 m/s at 10?C. If the pipe enlarges to a diameter of 12-cm, calculate the reduced velocity. Also, calculate the mass flux rate and the flow rate.

Reference no: EM13552747

Questions Cloud

What is the peak discharge at the reach outlet : Use the Muskingum method to route a flood through a reach a river. The base flow is 100 cfs, and the incoming flood flow increases 50 cfs every 2 hr over a 6 hr period and the subsides at the same rate.
Determine the change in storage during : Athletic Lake has a surface area of 75.96 km2. In September, the evaporation was estimated to be 3.20 inches and the precipitation was 3.45 inches. The average flow rate of the River Tiger into the lake was determined to be 3.5 m3/s and the average f..
Find the magnitude of the magnets magnetic dipole moment : A bar magnet is oriented with its magnetic dipole moment at 53.5° to the direction of a 0.0629-T magnetic field, Find the magnitude of the magnet\'s magnetic dipole moment
Estimate the separation distance of the wires : Two long parallel wires carry currents of 2.83 A and 5.41 A. Find the separation distance of the wires expressed in millimeters
Calculate the mass flux rate and the flow rate : Water is flowing in a 6-cm diameter pipe at 20 m/s at 10?C. If the pipe enlarges to a diameter of 12-cm, calculate the reduced velocity. Also, calculate the mass flux rate and the flow rate.
Sodium chloride reacts with excess sulfuric acid : Sulfuric acid reacts with sodium chloride to form aqueous sodium sulfate and hydrogen chloride gas. How many mL of gas form at STP when 0.117 kg of sodium chloride reacts with excess sulfuric acid?
Which density might be expressed : Which density might be expressed
Estimates of the force on each : Fill two rubber balloons with air. Suspend both of them from the same point and let them hang down on strings of equal length. Make order-of-magnitude estimates of the force on each
What is the symbol that correspond with it : A reaction is carried out at 20 degree celcius what is the symbol that correspond with it?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the overall efficiency of the system

A gas stream with a particulate loading of 20.0g/m^3 is passed through a 70%-efficient cyclone followed by a 95%-efficient ESP. Calculate the overall efficiency of the system.

  Determine the actual detention time observed in the field

Determine the actual detention time observed in the field of two circular settling tanks with depth 3.5 m that was designed to have an overflow rate not exceeding 60 m3/m2-day and a detention time of at least 2 hour.

  What would be the fraction converted in a half-hour run

A 10-min experimental run shows that 75% of a reactant is converted to a product by a zero-order reaction rate. What would be the fraction converted in a half-hour run. Assume the reactor is a batch reactor.

  Specify the radius in mm to the centerline of a bend

Specify the radius in mm to the centerline of a 90 degree bend in a 1 in type k copper tube to acheive the minimum energy loss. For such a bend carrying 250 L/min of water at 80'C, compute the energy loss.

  Horizontal distance between the points

A runs slope a distance of 156.777 m from one point to another point at a rate of +1.5%. What is the corresponding horizontal distance between the points?

  The long-term average january precipitation in the colorado

the long-term average january precipitation in the colorado river basin is 1.11 inches with a standard deviation of

  Discuss and explain the apparent contradiction

The actual weight of the Rectangular Aluminum Beam (used in Task 3) is 25 grams, while the actual weight of the Square Aluminum Box Beam is only 5 grams. But under the maximum applied force (500 grams),

  Determine the forces applied at a and b

Knowing that these forces are equivalent to a force-couple system at C consisting of the force C= (- 8 N)i+ (4 N)k and the couple Mc =(360 N ⋅ m)i, determine the forces applied at A and B when Az = 2 N.

  Determine the concentration of carbon in this alloy

The microstructure of an iron-carbon alloy consistsof proeutectoid ferrite and pearlite; the mass fractions of thesetwo microconstituents are 0.174 and 0.826, respectively. Determinethe concentration of carbon in this alloy.

  Determine the pressure at a closed valve attached to tank

In a certain chemical plant, a closed tank contains ethyl alcohol to a depth of 50 ft. Air at a pressure of 25 psi fills the gap at the top of the tank. Determine the pressure at a closed valve attached to the tank 10 ft above its bottom.

  Determine the minimum size of the pad footing 2 metre wide

Determine the minimum size of the pad footing 2 metres wide for a steel column if a factor of safety of 2.0 is recommended (include an estimate of self weight of the footing in your calculations). The total load of the column is 447.644kN

  How much money is equivalent to lump sum with interest rate

how much money today is equivalent to lump sum of $100,000 in 20 years with interest rate of 6% per year compounded (a)monthly, (b)quarterly, (c)semiannually

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd