Calculate the mass emissions rate of no2 in kg/day

Assignment Help Civil Engineering
Reference no: EM13539105

Over a 20-minute sampling time, 40.0 grams of water are collected. Calculate the NO2 concentration in the stack.

After calculation there is 737 ppm Of NO2 in the stack. How Do proceed through the next part of the problem??

Assuming that the average stack gas velocity is 10.0 m/s and stack is circular with a 3.0 meter diameter, calculate the mass emissions rate of NO2 in kg/day.

Reference no: EM13539105

Questions Cloud

Calculate the inner diameter if you are designing for a max : Assume 0.1 kg of air initially at 200 kPa and 300 K undergoes an isothermal compression process to a volume of 0.02 m3. Find the work done in the process and the final pressure. Sketch the process on a P-V diagram.
Suggest an alternative engineering design solution that : Stormwater controls are typically designed by civil engineers. Stormwater is collected in pipes below the ground and routed to nearby surface water
Which humans can be exposed to toxic chemicals in the : In 1908, H. Chick reported an experiment in which he disinfected anthrax spores with a 5% solution of phenol. The results of his experiment are tabulated below. Assuming the experiment was conducted in a completely-mixed batch reactor, determine the ..
How the method can assist an operations manager : Write a brief paragraph explaining how the method can assist an operations manager
Calculate the mass emissions rate of no2 in kg/day : Assuming that the average stack gas velocity is 10.0 m/s and stack is circular with a 3.0 meter diameter, calculate the mass emissions rate of NO2 in kg/day.
What variable is being optimized in this analysis : What variable is being optimized in this analysis?
Can the bitcoin legitimately be defined as money : 1)Can the bitcoin legitimately be defined as money?
Estimate the storage change for this lake during the month : How much extra water does a 21.5 ft, 175-lb concrete canoe displace compared to an ultra-lightweight 38-lb Kevlar canoe of the same size carrying the same load?
Business or employees : Business or Employees

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine how many tons of aggregate will be needed

Base course aggregate has a target dry density of 119.7 lb/cu ft in place. It will be laid down and compacted in a rectangular street repair area of 2000 ft*48ft*6in.

  What are the inputs needed to determine stress a polymer

What are the inputs needed to determine stress a polymer with a fixed end on one side, and the other with a tension force of 50,000 lbs a year after the load is applied

  Find relation between reflection nd transmission coefficient

What is the relation between reflection and transmission coeffients of a sea wall

  Calculate what is the volume of rock in the rock pile

A storage pile of crushed rock is 100ft by 100ft square at its base and 50 ft by 50 ft square on the top. The pile is 25 ft high. What is the volume of rock in the rock pile

  Is this stress tension or compression

If the rod is snugly fitted against two immovablenonconducting walls at a temperature of 15oC and thenheated uniformly to at 115oC, what is its length at115oC? If the modulus of elasticity of steel is 207 GPa,what is the stress induced in the bar? Is..

  What will be approximate distance from pipe entrance

Oil with a kinematic viscosity of 0.0035ft3/s flows through a 4-in-diameter pipe with a velocity of 15ft/s. What will be the approximate distance from the pipe entrance to the first point

  Design temperature and residence time have been established

Assume that the design temperature and residence time have been established as 1300 degrees F and 0.6 seconds, respectively. The type of burner used in the process requires outside air at a mass ratio of 12:1 (air to fuel gas).

  Find what depth of aggregate is needed at the angle theta

A 2000-lb wheel load is to be supported by aggregate over soil with a maximum bearing pressure of 1000 lb/sqft. What depth of aggregate is needed if the angle theta is 40 degrees

  Find metric tons of gravel required to fill a excavated area

Calculate the metric tons of gravel required to fill an excavated area 70 meters by 50 meters by 2 meters deep if the gravel has a density of 1890 kg/(m^3).

  Explain why the boss is concerned for the materials

A young engineer is asked to design a thermal protection barrierfor a sensitive electronic device that might be exposed toirradiation from a high-powered infared laser.

  What is the minimum tractive effort required for vehicle

A 3000 lb vehicle has a drag coefficient of 0.32 and a frontal area of 30 ft2. What is the minimum tractive effort required for this vehicle to maintain a 65 mph speed on a 2% upgrade through an air density of 0.002045 slugs/ft3

  Compute the final temperature and pressure of the gas

A tank is divided into two equal chambers by an internal diaphragm. One chamber containes methane at a pressure of 500 bar and a temperature of 20 C, and the other chamber is evacuated.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd