Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Application: TE/TM waves in strip lines. A parallel plate waveguide is made of two wide strips, separated by a fiberglass sheet d = 0.5 mm thick which has a relative permittivity of 3.5. Neglect any effects due to the edges of the strips (that is, assume the strips are infinitely wide) and calculate:
(a) The lowest TM mode possible.
(b) The lowest TE mode possible.
(c) If a wave at twice the lowest TE cutoff frequency propagates along the waveguide, calculate the wave impedance for the TE and
TM modes and compare with the wave impedance for TEM modes.
the number of times the hawser should be wrapped around the bollard if a 20,000-lb force is to be resisted by the same 80-lb force.
Determine the least area of a cross section of an ASTM-a36 steel bar required to support a tensile load of 100,000 lbs. the allowable unit stress is 36,000 psi. (Ans. nearest 100th of an inch squared)
in a brinell hardness test a 1500-kg load is pressed into a specimen using a 10-mm diameter hardened steel ball. the
Many cross sections can be approximated by a series of rectangles as shown. Write a computer program that can be used to calculate the products of inertia of cross sections of this type with respect to horizontal and vertical centroidal axes.
Ten pounds-mass of R-22 is at an initial volume of 4.059 ft3 and pressure of 200 psia. It is compressed isobaric ally until its volume is two-thirds of its initial volume. The piston is then held in place as the refrigerant cools until its temperatur..
temperature in state college pa on 31st december 2012 was 22 f. if the barometric pressure was 100 kpa and the humidity
Determine the heat transfer coefficients for the two cases, assuming the plate behaves as a spacewise isothermal object.
a solar hot-water system stagnates at 85 c under insolation of 740 wm2 and an ambient temperature of 17 c. find its
when environmental crews started cleaning up a closed government wwii laboratory they discovered thousands of unlabeled
1. For each case, determine the specified property at the indicated state. Locate the state on a sketch of the T-y diagram.
Required electromagnetic torque during acceleration and during deceleration. Maximum DC input current to the inverter during acceleration (assume efficiency of motorinverter combination is 91%). Acceleration time from zero speed to 1400r/min.
a garden hose is open at one end and capped closed at the other. a swimmer in an above-ground pool fills the hose
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd