Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Lift on a circular arc Using the software FoilSimU III, calculate the lift coefficient of a circular arc with 5% camber and 3% thickness for angles of incidence between 0 and 30?. The software FoilSimU III was developed by the NASA and can be obtained at {https://www.grc.nasa.gov/ www/K-12/UndergradProgs/index.htm}.
The natural water content of a saturated soil is 41% and its shrinkage limit = 20%. Gs (sp. gravity of solids) = 2.75. Calculate the percentage change in volume based on its volume at its natural water content if the soil is dried to a water conte..
A well mixed sewage lagoon is to be constructed to process 100,000 gallons per day of raw sewage. The pollutant concentration in the raw sewage to be discharged into the lagoon is 200ppm.
The concentration of Chemical Oxygen Demand (COD) in the effluent from this system is 25 mg L-1. The growth rate of the organisms in this case is 0.9 days-1. The activated sludge tank has a volume of 50 m3 and the flow rate through it is 500 m3 da..
a 4ft-long, 1-in-diameter shaft rotates inside an equally long cylinder that is 1.02 in. in diameter. Calculate the torque required to rotate the inner shaft at 2000 rpm if SAE-30 oil at 70 degrees F fills the gap
Determine the support reactions for the truss and determine the force in members BC, CF and FE and state if the members are in tension or compression.
The yield stress for A-36 is 250 MPa. Using factor of safety against yield of 1.25, determine an appropriately sized beam such that the radius of curvature is not less than 140m. E= 200 GPa, G= 77.2 GPa.
Find the required diameter of the force main PA, (dPA), if the pressure at point A is not allowed to drop below 370 kPa. Determine the required diameter of pipe BC, (dBC), if the maximum allowed head loss in the network ABC is 0.003 m/m.
determine the horizontal spacing of the vertical drains if the drains are installed in triangular grid to reach 90% of primary consolidation in 1.5 years after the commencement of fill placement
The rate of flow through a trapezoidal open channel is 20 m^3/s and the mean velocity of flow is 1m/s . the side slope is 1:1 and the bed slope is 1 in 5000. Assume Chezy's constant C as 60, find the bottom width and the depth of water channel.
A 4x4 carries an axial compressive force caused by dead, love, and roof live loads. Lumber is No. 1 Douglas Fir-Larch. Cm = 1.0 , Ct = 1.0, Ci = 1.0. The unbraced length of the member is 12 ft.
A 4 in. in diameter shaft moves through a well-oiled sleeve that is 12 in. long. The force required to move the shaft is 25 lbf, and the shaft velocity is 5 in./s.
You have two wires connected end to end. Wire 1 is copper and wire 2 is made using a special carbon conductor. Wire 1 has a resistance of 0.215 ohms/ft and is 500 ft long. Wire 2 has a resistance of 0.141 ohms/ft and is 700 ft long.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd