Calculate the level at tpl of a vertical crest curve

Reference no: EM13299590

A vertical crest curve has an approach grade +6% and a departure grade -6%. The Vertical intersection point level is 125 m. It is proposed to use a curve 720 m long. Calculate the level at TPl.

Reference no: EM13299590

Questions Cloud

Describe what are the different dimensionless groups : What are the different dimensionless groups that describe a golf ball. A golf ball has two velocities, a spin velocity and a forward velocity.

Determine what are the major nutrients required for growth : What are the major nutrients required for growth of microbial population in wastewater treatment plants. List the major differences and similarities between hetrotrophic bacteria and nitrifying bacteria.

Discuss the difference between economic costs and accounting : Discuss the differences between the long run and the short run. What are the implications for the firm of making decisions in the short run and making decisions in the long run? Discuss the limitations and freedom of the two time horizons.

Find and plot initial vertical effective stress distribution : A 35 feet diameter oil storage tank is built on a 100 ft thick soil layer. The tank exerts an uniform pressure of 1000 pcf on the ground surface. The groundwater table is 10 ft below the ground surface.

Calculate the level at tpl of a vertical crest curve : A vertical crest curve has an approach grade +6% and a departure grade -6%. The Vertical intersection point level is 125 m. It is proposed to use a curve 720 m long. Calculate the level at TPl.

Develop an estimate of the volumetric flow rate of air : Develop an estimate of the volumetric flow rate of air that will be required for aeration of the mixed liquor in an activated sludge system.For this calculation, assume that the (ultimate) CBOD is 200 mg/L and (ultimate) NBOD is 50 mg/L.

Determine the dead load per unit of length on a beam : A floor system consists of wide flange steel beams (W18 x 60) equally spaced at 8ft center to center. A 6inch reinforced concrete slab spans between beams. The bottom of the slab is coated with plaster and the top of the slab has ¾inch hardwood fl..

Determine properties of the material poissons ratio : At the proportional limit, . gage length of a -diameter alloy rod has elongated . and the diameter has been reduced . The total tension force on the rod was . Determine the following properties of the material

Which would require less wood and by what percentage : An engineer is to design a channel lined with planed wood to carry 2 m3/s of water on a given slope. The channel cross section can be either a 90 degree triangle or a square. Which would require less wood and by what percentage

User Account

All Pages