Calculate the induced emf in the loop

Reference no: EM13545737

A circular loop of wire of 250.0 turns is placed perpendicular to a uniform magnetic field of .500 T. The area of the loop is decreasing at a rate of 1.00* 10^-3 m^2 in .400 s. Calculate the induced emf in the loop. please answere in depth

Reference no: EM13545737

Questions Cloud

Combination of an applied force and a friction force produce : The combination of an applied force and a friction force produces a constant total torque of 36.6 N · m on a wheel rotating about a fixed axis. The applied force acts for 6.20 s. During this time, the angular speed of the wheel increases from 0 to..

Find the magnitude of the torque the net thrust : A model airplane with mass 0.757 kg is tethered to the ground by a wire so that it flies in a horizontal circle 29.7 m in radius. The airplane engine provides a net thrust of 0.798 N perpendicular to the tethering wire.

An electric motor turns a flywheel through a drive belt : An electric motor turns a flywheel through a drive belt that joins a pulley on the motor and a pulley that is rigidly attached to the flywheel as shown in the figure below. The flywheel is a solid disk with a mass of 57.0 kg and a radius R = 0.625..

The secondary coil of a transformer provides the voltage : The secondary coil of a transformer provides the voltage that operates a small radio. The turns ratio of the transformer is 60.0/1 (primary/secondary). The primary coil is plugged into a 120.0 V outlet. If the current in the secondary is 4.00 mA, fin..

Calculate the induced emf in the loop : A circular loop of wire of 250.0 turns is placed perpendicular to a uniform magnetic field of .500 T. The area of the loop is decreasing at a rate of 1.00* 10^-3 m^2 in .400 s. Calculate the induced emf in the loop. please answere in depth

What is value and units of resistivity of resistive material : A 20.0 m long wire with a square cross-section of 2.0 mm x 2.0 mm is made of a resistive material. When a potential difference of 40V is placed across the length of the rod, a current of 2.0 A is produced. What is the value and units of the resistivi..

What is the final potential difference between the plates : A 200-Volt battery is connected to a parallel-plate capacitor that has a dielectric slab (k= 2) filling the space between the plates. The plates are 10cm x 10cm and are 3mm apart.

Coefficient of kinetic friction between block and surface : A bullet of mass 7.00g is fired horizontally into a wooden block of mass 1.29kg resting on a horizontal surface. The coefficient of kinetic friction between block and surface is 0.250. The bullet remains embedded in the block, which is observed to..

What is velocity of second car measured from center of mass : A 1000 kg car is traveling at a speed of 20 m.s-1 east and a 1200 kg car is traveling at 22 m.s-1 west. What is the velocity of the second car measured from the center of mass reference frame of the system?

User Account

All Pages