Calculate the impulse of ideal filter with cut-off frequency

Assignment Help Electrical Engineering
Reference no: EM13295607

calculate the impulse of an ideal filter with cut-off frequency of a)2KHz, and b)3KHz for a signal sampled with a rate 8000 samples/sec.

Reference no: EM13295607

Questions Cloud

Estimate the phase angle between the current and the voltage : A 80.0 Hz generator with an rms voltage of 150 V is connected in series to a 3.20 k ohm resistor, estimate the phase angle between the current and the voltage
What is the value today of the following payments : What is the value today of the following payments: Year 2 $600, Year 4 $1,300, Year 5 $900, and Year 6 $1,800, if the appropriate interest rate is 5%? What is the value of these payments as of the end of year 4?
Explain the boiling points of pure benzene : Include on the graph the boiling points of pure benzene and pure methanol and the boiling point of the azeotrope. Describe the behavior for a mixture that is initially rich in Benene (90%) and then for a mixture that is initially rich in methanol ..
How much are the monthly loan payments : She will have to borrow $3,650 in order to make the trade. The bank provides a loan that must be paid off in 18 months. The loan charges interest at the rate of .5% per month. How much are the monthly loan payments?
Calculate the impulse of ideal filter with cut-off frequency : calculate the impulse of an ideal filter with cut-off frequency of a)2KHz, and b)3KHz for a signal sampled with a rate 8000 samples/sec.
Calculate the max static friction force that acts on block : a block with a mass of 2.50kg is resting on a ramp. find the max static friction force that acts on the block.
What interest rate is that investor receiving : If an investor were to purchase an annuity for $3,200 to receive $260 at the end of each year for 16 years, what interest rate is that investor receiving?
Explain the boiling point of cyclohexene : Why is the boiling point of a cyclohexene and water mixture less than 83 degrees, the boiling point of cyclohexene
Find what is the expression for the threshold value : In a binary communication system over an additive white Gaussian noise channel, two messages represented by antipodal signals andare transmitted. The probabilities of the two messages arep and 1-p, respectively

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Sketch the spectrum of the original signal nd sampled signal

a. Sketch the spectrum of the original signal and the sampled signal from 0 kHz and 25 kHz. b. Sketch the recovered analog signal spectrum if an ideal lowpass filter with a cutoff frequency of 4 kHz is used to filter the sampled signal. X(f) 10k 2..

  Explain function of the prime mover in generating process

A)What is the standard frequency of the AC voltage generatedand distributed by an electrical utility. B)Explain the function of the prime mover in the generating process.

  Determine the average power absorbed by the element

The voltage and current for a circuit element are v(t) = 10 + 6 cos(377t + -60) - 7 cos(754t + 10) V & i(t) = 7 + 4 cos(377t + -20) + 5 cos(754t + 10), with the phase angles given in degrees.

  Determine the count sequence for the counter

Draw a diagram for a MOD-10 Johnson counter using a 74HC164. Makesure that the counter will start the proper sequence when it isturned on. Determine the count sequence for this counter and draw the decoding circuit needed to decode each of the 10 ..

  Determine the power output and the annual energy produce

A 1.2 MW wind turbine has a rotor diameter of 64 m. the turbine operates in an area with an average wind velocity of 7.5 m/s and the air density of 1.18 kg/m^3. the turbine power coefficient including the unit efficiency is 42.8 percent.

  Design 8-bit programmable microprocessor-compatible timer ic

design an 8-bit programmable microprocessor-compatible TIMER IC by doing the following steps: Specify, draw , and clearly label( the functional name), the complete set of 8-bit registers that will be needed in the TIMER.

  Evaluate required received power that achieves a bit error

Data at a rate of 2 Mbps is to be transmitted via a pass-band communication system whose carrier frequency is 500MHz. A binary antipodal system with roll-off factor of 0.2 is used for this communication. The AWGN single-sided power spectral densit..

  Calculate the thevenin equivalent impedance zth

1) Calculate the open circuit voltage VOC (ZL removed) (magnitude and phase angle) 2) Calculate the Thevenin Equivalent impedance ZTH for this circuit (magnitude and phase angle)

  Develop a coherent demodulation for the modulated signal

Use a modulation index of 50 percent and a sampling rate of 160 kHz. In this project, develop a coherent demodulation for the modulated signal. Assume there is no channel error.

  Determine how deeply the signal penetrates for the objects

An object in a microwave oven 25 cm in diameter and 4 cm thick is being warmed. Determine how deeply the signal penetrates if the objects εr is 12.5 and σ is 2 S/m at a frequency of 2.5 GHz. Assume that the plane wave calculations are valid.

  Calculate the apparent power absorbed by the motor

A 60 hp, 3-phase motor absorbs 50 kW from a 600 V, 3-phase line. If the line current is 60 A, calculate the following: (a) The efficiency of the motor (b) The apparent power absorbed by the motor (c) The reactive power absorbed by the motor

  Compute the transfer function

In this project we will consider the control of a synchronous generator supplying electricity to the grid.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd