Calculate the heat transfered to the air

Assignment Help Mechanical Engineering

Reference no: EM13709570

Air is isothermally and reversibly compressed in a piston-cylinder device from an initial volume of 1.00 L and initial pressure of 100 kPa to a final volume of 0.100 L. Calculate:

A) the work done on the air (J)

B) the heat transfered to the air (J)

Reference no: EM13709570

Questions Cloud

Find fluids specific weight, density : A container holds .07m^3 of hydraulic fluid with a specific gravity of .9. find fluids specific weight, density, and weight.

Premature rate of failure on the road : A tire company has determined that its tires have a 1% premature rate of failure on the road. What is the chance that none of the 16 tires shipped to a retailer will have a premature failure?

Examples using expansion coefficients : Using technical content provide some examples using expansion coefficients, use the following to produce 2 examples. A copper pipe 5m long is raised in temperature from 373k to 1000°C. Calculate the expansion of the pipe? What percentage increase in ..

Circuit boards are manufactured on sheets and tested : Circuit boards are manufactured on sheets and tested. On average, there are 3 defects per sheet. What are the chances of 10 defects on a given sheet, no defects on a sheet, and more than 1 defect on a sheet?

Calculate the heat transfered to the air : Air is isothermally and reversibly compressed in a piston-cylinder device from an initial volume of 1.00 L and initial pressure of 100 kPa to a final volume of 0.100 L.

Determine the mechanical power required to drive compressor : Air enters the compressor of a turbofan engine at –20°C and 60 kPa, with a flow rate of 95 kg/s and speed of 170 m/s. At the compressor exit, pressure is 1830 kPa, temperature is 455°C, and speed is 134 m/s.

The internal energy of the piston-cylinder increases : 10 kJ of heat enters a piston-cylinder. The internal energy of the piston-cylinder increases by 2 kJ. How much work is produced by the piston-cylinder?

Calculate the power output of the turbine : Steam enters a turbine at a pressure of 16 MPa, temperature of 560°C, speed of 150 m/s, and a height of 3.5 m above ground. At the turbine exit, temperature is 45°C, the steam is saturated with 95% quality, the speed is 15 m/s, and the height is 0.8 ..

Find the initial pressure and mass of the system : Water in the pictured piston cylinder assembly has an initial quality of 10%. The piston cylinder is 20 cm in width and the piston is initially 40 cm high. Heat is added until the temperature of the steam reaches 500°C. While heat is being added the ..

User Account

All Pages