Calculate the fugacity and the fugacity coefficient

Assignment Help Chemical Engineering
Reference no: EM131155870

Problem 10.3:

At 50 °C, 1.2 bar, the system n-pentane (1), n-hexane (2), and n-heptane (3) exists ion vapor-liquid equilibrium. The mole fractions in the two phases are: x1 = 0.6, x2 = 0.2, x3 = 0.2 in the liquid; and y1 = 0.87, y2 = 0.1, y3 = 0.03 in the vapor.

a) Calculate the fugacity and the fugacity coefficient of each component in the vapor and in the liquid. Fill out the table below but explain your work.

b) Calculate the chemical potential of n-heptane in the liquid. The reference state is the ideal-gas state at 200 K, 35 bar.

Additional information: Ideal-gas heat capacity of n-heptane: CP = 200 J/mole K.

Reference no: EM131155870

Questions Cloud

Calculate the amount of heat removed : Additional data: Assume for simplicity that the ideal-gas heat capacities are constant: n-hexane = 176 J/mol K; n-octane = 247 J/mol K.
Analyze five way in which soa reduce total cost of ownership : Analyze five ways in which SOA reduces the total cost of ownership. Examine five ways in which using XML enables data and information exchange between clients and servers using Web Services in an SOA environment.
How is technology used in protecting critical infrastructure : Specifically, how do you think interagency cooperation can be stifled simply because of required bureaucratic communication procedures and protocol? How is technology used to improve communication breakdowns?
New orientation or onboarding procedures : Topic for Discussion: Discuss what your experiences have been with new orientation or onboarding procedures into a new organization. What was your best experience and why? The worst? After reading the lesson from the textbook and conducting indepe..
Calculate the fugacity and the fugacity coefficient : At 50 °C, 1.2 bar, the system n-pentane (1), n-hexane (2), and n-heptane (3) exists ion vapor-liquid equilibrium. The mole fractions in the two phases are: x1 = 0.6, x2 = 0.2, x3 = 0.2 in the liquid; and y1 = 0.87, y2 = 0.1, y3 = 0.03 ..
Give an example of question that might be found on a survey : For example, asking an individual whether he or she owns a car could lead to various results depending on whether owning a car means paying the loan on the car versus the entire car being paid off. Also, does this imply owning trucks as well?
New employees learn attitudes-knowledge : Onboarding "Process by which new employees learn attitudes, knowledge, skills and behaviors required to be effective in an organization" pages 214-216. Read the following article addressing the subject of transferring the workplace culture during ..
Human resources management and development : For this assignment, you will develop a PowerPoint presentation of 10-15 slides  that provides a synopsis (in your own words) of the general themes learned about Human Resources Management and Development from the perspectives of:
Calculate the fugacity of saturated liquid methane at 250 k : A solution with composition x1 = 0.2 is to be stored at 250 K. It is important to avoid the formation of vapor. What is the minimum pressure required?

Reviews

Write a Review

Chemical Engineering Questions & Answers

  Determine the speed of prime mover of the generator

A synchronous generator has a rotor with six poles and operates at 60 Hz.

  Determine the concentration of product at t=2h assuming p0=0

Determine the concentration of biomass at t=2h assuming quasi steady state. If alpha=0.2g/g Determine the concentration of product at t=2h assuming P0=0

  Determine the synchronous speed in revolutions

Determine the synchronous speed in revolutions per minute and the useful torque in new ton meters of a 200-hp, 60-Hz, six-pole synchronous motor operating at its rated full load (1 hp ≅ 746 W).

  Calculate the ratio of the total flux to the diffusion flux

Dry ice is placed in the bottom of a capillary tube 6.2 cm long. Air is blown across the top of the tube.

  Total volume of hydrogen

The total volume of hydrogen gas needed to fill the Hindenburg was 2.0  108 L at 1.0 atm and 25C. How much heat was evolved when the Hindenburg exploded, assuming all of the hydrogen reacted?

  What percentage of the dissolved salt crystallizes

If a saturated solution of NaHCO3 at 60°C is cooled and comes to equilibrium at 30°C, what percentage of the dissolved salt crystallizes?

  Different types of zinc coating

Why is it important - where does galvanising fit into possible corrosion protection strategies?)

  Evaluate reflux ratio

Reconsider the Methanol Water Distillation. If the feed stream contains 60 mol % methanol, reevaluate reflux ratio, number of stages required, and the column diameter.

  The final concentration of the dye in the barrel

Into a barrel containing 33.2 bbl (US) of water containing 0.0012 mol/L of a blue dye you pour V2 yd3 of water containing 8.91 M of the dye. The final concentration of the dye in the barrel is 7.91 mol/m3 after it's well-mixed. What is V2 is yd^3?

  Overall reaction in a commercial heat pack

The overall reaction in a commercial heat pack can be represented as: 4Fe(s)+  3O2(g) yields 2Fe2O3(s); delta H=1652 kJ a. How much heat is released when 4.00 mol iron is reacted with excess O2?

  Determine a metric to quantify the reactor performance

Choose an initial guess for reactor temperature and pressure within the range provided and simulate the process described - Determine a metric to quantify the reactor performance then use this parameter to optimize the reactor temperature and pressu..

  Determine the optimum economic thickness of insulation

The air-film coefficient at the outside of the insulation may be assumed constant at 2.0 Btu/(h)(ft2)(°F) for all insulation thicknesses

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd