Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A stream of Liquid n-pentane flows at a rate of 50.4L/min into a heating chamber, where it evaporates into a stream of air 15% in excess of the amount needed to burn the pentane completely. The temperature and gauge pressure of the entering air are 336 K and 208.6 kPa. The heated gas flows into a combustion furnace in which a fraction of the pentane is burned. The product gas which contains all of the un-reacted pentane and no CO. goes to a condenser in which both the water formed in the furnace and the un-reacted pentane are liquefied. The uncondensed gas leaves the condenser at 275 K and 1 atm absolute. The Liquid condensate is separated into its components and the flow rate of the pentane is measured and found to be 3.175 kg/mm.
(a) Calculate the fractional conversion of pentane achieved in the furnace and the volumetric flow rates (L/min) of the feed air, the gas leaving the condenser, and the liquid condensate before its components are separated.
(b) Sketch the apparatus that could have been used to separate the pentane and water in the condensate. Hint: Remember that pentane is a hydrocarbon and recall what is said about oil (hydrocarbons) and water.
An idealized reservoir contains an ideal gas at a pressure of 4410 psia and a temperature of 91degrees C. Under these conditions the volume of this gas in the reservoir is 10^9 ft^3. What would be the volume of this gas at standard temperature and co..
steam enters a well-insulated turbine operating at steady state with negligible velocity at 4 mpa 320c. the steam
an automatic automotive transmission casing has a shape of a rectangular box with side dimensions 40 cm x 30 cm x 50
an 18-m-long steel wire of 5-mm diameter is to be used in the manufacture of a pre-stressed concrete beam. it is
in an ideal dual combustion cycle conditions at the commencement of adiabatic compression are 93 kpa 0.05 m3 and 24degc
a supersonic aircraft consumes 5320 imperial gallons of kerosene per hour of flight and flies an average of 14 hours
a block with mass m 13 kg is projected up a rough incline angled at ? 30 degrees to the ground with a speed of v 6.4
200mm DN pipeline has to deliver 80m³/h of water at a discharge pressure of 5,550 kPa. Approximately how many pump stations would be needed for a pipeline 300km long?
a spherical pressure vessel is formed of 16-gauge 0.0625 in cold drawn aisi sheet steel. if the vessel has a diameter
A steady-state, well insulated turbine operated in two stages in series using steam . The first stage has an efficiency of 85% and the second stage 90%. Steam enters the first stage at 400 C degree and 4 MPa and exits at 1.5 MPa.
the masses of the bar and the disk are 5 kg and 10 kg respectively. the coefficient of kinetic frictionnbspbetween the
a house that was heated with electric resistance heaters consumed 1200 kwh of electric energy in a winter month. if the
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd