Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A strain gauge is used to measure the tension force in a 0.75-in. diameter bar of steel. The strain gauge has a nominal resistance of 180 ? and a GF of 4. The strain gauge is connected to a bridge (which is supplied with 10 Vdc). The bridge was initially balanced. After the bar is put under tension, the bridge output voltage goes to 0.0006 Vdc. Draw a schematic of the set up and calculate the force on the bar.
What is the common-mode rejection ratio (in dB) if the output voltage is measured to be 2.0 Vp-p when the input terminals are connected together and a 0.1 Vp-p voltage is applied between the inputs and ground.
Sketch a block diagram of the arrangement and calculate suitable values of pad resistance if both the amplifier and the line have a characteristic impedance of 600 Ohm.
(a) Three volts is applied across a 1-cm-long semiconductor bar. The average electron drift velocity is 104 cm/s. Find the electron mobility. (b) If the electron mobility in part (a) were 800 cm2/V-s, what is the average electron drift velocity
A conducting bar of length l rotates about one end in a uniform magnetic field at a frequency of ω rad/sec. Determine the potential difference between the two ends using (a) Faraday's law of induction.
Assuming a 24 dB link margin is needed to account for fading and loss due to heavy rainfall on the longest link, while 12 dB link margin is sufficient for the shorter link, what transmitter powers are needed at each of the four transmitters
Read the binary number from the user and store it into a C string (i.e. char[ ]) The c string shall be able to accommodate a 32 bit binary number, note each digit in the binary number is a character, and there must be a null character at the end ..
A 100V dc series motor has an armature resistance of 0.2 ohm and field resistance of 0.25 ohm. The motor runs at a speed of 600 rev/min when the shaft torque is 27.14 Nm. Friction and windage losses at this speed are 300W.
Hockey puck B rests on a smooth ice surface and is struck by a second puck A, which has the same mass. Puck A is initially traveling at 14.6 and is deflected 28.0 from its initial direction. Assume that the collision is perfectly elastic.
a. Sketch the spectrum of the original signal and the sampled signal from 0 kHz and 25 kHz. b. Sketch the recovered analog signal spectrum if an ideal lowpass filter with a cutoff frequency of 4 kHz is used to filter the sampled signal.
A composite has a cross-sectional area of 320 mm2 and is subjected to a longitudinal load of 44,500 N. The continuous and aligned fiber-reinforced composite is to be produced consisting of 30 vol% aramid fibers and 70 vol% polycarbonate matrix.
Design a series resonant circuit to have a bandwidth of 400 Hz using a coil with a Ql of 20 and a resistance of 2. Find the values of L and C and the cutoff frequencies.
Binary data is transmitted at the rate of Rb bits/sec over a channel occupying a bandwidth B and the channel SNR=3 dB. If the data bit rate is increased to 2.65Rb and the bandwidth is increased to 1.75B i.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd