User Account

All Pages

Calculate the flux per pole

Assignment Help Electrical Engineering
Reference no: EM13265753

A six pole, 400 V d.c. motor draws 110 A from the supply. The shunt field resistance is 200 Ohm and the armature resistance is 0.5 Ohm. The armature is wave wound with 600 conductors operates at a speed of 1200 rev/min when supplying full load.

RATING: 40 kW
POLES: 6
VOLTAGE: 400 V
CURRENT: 110 A
SPEED: 1200 rev/min
CONNECTION: SHUNT

Calculate the flux per pole.

Reference no: EM13265753

Questions Cloud

Determine what is the resonant frequency of a series circuit : what is the resonant frequency of a series circuit consisting of a 100 pf capacitor, a 10 k ohm resistor, and a 1 mH inductor
What must the six-month forward rate be to prevent arbitrage : What must the six-month forward rate be to prevent arbitrage?
Explain hcl solution is needed to completely neutralize : what volume of a 0.500 M HCL solution is needed to completely neutralize 10.0ml of a 0.200M Ba(OH)2 solution
What is the maximum initial cost the company : What is the maximum initial cost the company would be willing to pay for the project?
Calculate the flux per pole : A six pole, 400 V d.c. motor draws 110 A from the supply. The shunt field resistance is 200 Ohm and the armature resistance is 0.5 Ohm. The armature is wave wound with 600 conductors operates at a speed of 1200 rev/min when supplying full load.
Obtain the magnification of the image : An arrow is placed 28.7 cm in front of a convex lens (f=15.0 cm). The convex lens is followed by a concave lens (f= 21.5 cm) 12.8 cm fro the convex lens. obtain the magnification of the image
What is the amount of interest revenue recognized by seller : On June 8, Alton Co. issued an $80,000, 6%, 120-day note payable to Seller Co. Assume that the fiscal year of Seller Co. ends June 30. Using the 360-day year in your calculations, what is the amount of interest revenue recognized by Seller in the ..
What is your best estimate of the companys cost of equity : If the stock sells for $39 per share, what is your best estimate of the company's cost of equity?
How much steam must be condensed into the water : A 60.0 g copper calorimeter cup contains 200.0 g of water at 22.0 Co. How much steam must be condensed into the water

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the value procedures at the primary output

draw a digital design consisting of 2 input AND gates and three inverters, where an inverter is connected to each of the AND gates input and its output. For each of the four possible combinations inputs applied to the two primary inputs.

  Prove switching function can be written as exclusive-or sum

a) If m1 and m2 are minterms of n variables, prove that m1 OR m2 = m1 XOR m2 b) Prove that any switching function can be written as the exclusive-OR sum of the products where each product does not contain a complemented literal.

  Determine limits if the amplifier is replaced by opa300 unit

a 60-kHz sinusoidal signal is applied to an amplifier with a gain of k=2. the circuit is built with an lm741 opamp with power supplies +-13V. find the largest amplitude the signal may have before it is limited by slew rate constraints.

  Find critical frequency value with out converting to decibel

Use the formula for decibels, 20*log(|T|), to find out what the -3db value would be in Volts per volt when the pass band is 1 V/V, 2 V/V, 3 V/V. find the way to find this critical frequency value with out converting to decibels

  Determine the minimum clocking frequency required

Find the longest allowable evaluate time if the decay in output voltage is to be limited to .2V. If the precharge interval is much shorter then the maximum allowable evaluate time, find the minimum clocking frequency required.

  Find the complex exponential fourier series representation

find the complex exponential fourier series representation for a) x(t)=1 for t =1b) x(t)= t^2-1 for all t

  Compute the diameter in centimeters of a steel rod

compute the diameter in centimeters of a steel rod, an aluminum rod, and a copper rod, which can withstand a particular compression load.

  Determine the awg size of the extension cord

The resistance per 304.8 m of copper wire uses in the extension cord of AWG 14,12,10,8 and 6 are 2.58,1.62, 1.02, 0.64 and 0.41 respectively. Assume a 2% allowable voltage drop. Show all working .

  Construct a canonical sum of products-sop expression

A farmer owns two barns; one north of a creek and the other south of the creek. The farmer has a Cabbage, a Goat, and a Wolf. The Farmer needs to put each item in a barn every night. If the Cabbage and Goat are in the same barn

  Find what is the highest possible output voltage magnitude

ts diode acts as a constant 1.0 V drop. the input voltage is 12.0 V. tje ;pad os a 4 ohm resistor. what is the highest possible output voltage magnitude, and at what value duty ratio does it occur

  Show the truth table of a two-input exclusive-nor function

The output of an exclusive-NOR function is false only if exactly one of the inputs is true. Show the truth table of a two-input exclusive-NOR function, and implement it using AND gates, OR gates and NOT gates.

  Determine the time average power delivered to the load

An AC motor with impedance Z = 4.2 + j3.6 O is supplied by a 220 V, 60 Hz source. Determine the time average power delivered to the load.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd