Calculate the extreme-fibre stresses at mid-span

Assignment Help Civil Engineering

Reference no: EM13564982

1.The West Panhandle Gas Field is in the panhandle of Texas. Atmospheric pressure in the area averages about 13.2 psia. What are the standard conditions used to calculate gas quantities produced from this field? A pressure gauge on a wellhead reads 47.0. What is the pressure in psia? What is the pressure in atmospheres (absolute)?

2.Calculate the extreme-fibre stresses at mid-span for a simply supported prestressed concrete beam with a depth of 750mm, width 370mm and span of 7m under working live load of 65 kN/m and self-weight. The prestressing force, P = 2000kN, is applied through a parabolically draped tendon with a maximum eccentricity at mid-span of 150mm and zero eccentricity at the ends.

Reference no: EM13564982

Questions Cloud

What is the stress along the top edge and the bottom edge : A horizontal pre-stressing force of 500kN is applied to rectangler beam. the beam has a depth of 500mm and a width of 250mm. the force is applied at a distance of 80mm below the x-x axis. what is the stress along the top edge and the bottom edge caus..

What is the maximum column load in kips that could be placed : What is the maximum column load in kips that could be placed on a 4-ft square temporary footing on a sand for which the standard resistance is about N=15 and the water table is at the surface? A factor of safety of 2 is to be maintained against beari..

Determine the percent error n in replacing the sine and the : Determine the percent error n in replacing the sine and the tangent of an angle by the value of the angle in radians for angle values 5 degrees, 10 degrees, and 20 degrees. Explain the qualitative difference between the sine and tangent results

Determine the design esal if the design life is 20 year : A six-lane divided highway is to be designed to replace an existing highway. The present AADT (both directions) of 6000 vehicles is expected to grow at 5% per year. Assume SN = 4 and pt = 2.5

Calculate the extreme-fibre stresses at mid-span : Calculate the extreme-fibre stresses at mid-span for a simply supported prestressed concrete beam with a depth of 750mm, width 370mm and span of 7m under working live load of 65 kN/m and self-weight. The prestressing force.

Calculate the maximum pressure developed when a 10 in. thick : Calculate the maximum pressure developed when a 10 in. thick wall 10 ft high is to be poured at the rate of 3ft/hr at a temperature of 70 degrees F.

What is the steady state co concentration : What is the steady state CO concentration? c. Given the steady state CO mixing ratio in part above (assume 1 atmosphere pressure and 288 K) what is the resulting %COHb and what is the health impact if exposed to this concentration overnight while you..

Determine the required spacing of joists supporting : Determine the required spacing of joists supporting 3/4in. thick plywood that is to support an 8 in. concrete floor slab, assuming a construction live load of 50 psf and a formwork dead load of 10 psf. Use plywood with f' b= 1930 psi.

Estimate the percentage of time headways that will be 10 sec : At a specified point on a highway, vehicles are known to arrive according to a Poisson process. Vehicles are counted in 20-s intervals, and vehicle counts are taken in 120 of these time intervals.

User Account

All Pages