Calculate the emissions of sulfur dioxide

Assignment Help Civil Engineering
Reference no: EM13563763

Coal burned in power plants in the United States has a energy content of approximately 24 kJ/g and an average carbon content of about 62 percent (by wt). For almost all new coal plants, Clean Air Act emission standards limit emissions of sulfur dioxide (SO2) to 260 grams per million kJ of heat input (fuel value). They also restrict particulate emissions to 13 g/106 kJ.

Suppose the average plant burns fuel with 2% sulfur content (by wt) and 8% unburnable minerals called "ash." About 70% of the ash is released as "fly ash" and about 30% settles out of the firing chamber and is collected as "bottom ash." Assume that this is a typical coal plant with 3 units of heat energy required to deliver 1 unit of electrical energy.

a) Calculate the emissions of sulfur dioxide, particulates (fly ash), and carbon dioxide per kilowatt-hour of electrical energy produced. Assume that all of the carbon in the coal is released to the atmosphere.

b) Calculate the efficiency (percent removal) of the sulfur emission control system required to meet the sulfur emission limitations.

c)   Calculate the efficiency of the particulate emission control system required to meet the particulate emission limitations.

Reference no: EM13563763

Questions Cloud

Calculate a value of temperature that could be used : A correlation for particulate removal efficiency in an electrostatic precipitator (n) as a function of gas velocity (u) may be written in the form: n = 1 - e^-k / u.
Determine the proportional limit stress the modulus : At the proportional limit, a 32-mm-thick by 87-mm-wide bar elongates 10.2 mm under an axial load of 532 kN. The bar is 2.4 m long. Poisson%u2019s ratio, , for the material is 0.27.
Can one collector be temporarily taken out of service by : Dust is removed from the airstream of a municipal incinerator by four dust collectors operating in parallel, each handling 1/4 of the total airflow of 200 m3/min. The airstream contains 10 g/m3
Design the flexural reinforcement for this member : A rectangular concrete beam of width b = 24 inches is limited by architectual considerations to a maximum total depth of h = 16 inches. it must carry a total factored load moment of Mu = 400 ft-kips. Design the flexural reinforcement for this member,..
Calculate the emissions of sulfur dioxide : Calculate the emissions of sulfur dioxide, particulates (fly ash), and carbon dioxide per kilowatt-hour of electrical energy produced. Assume that all of the carbon in the coal is released to the atmosphere.
What is the second year book value for equipment with : What is the second year book value for equipment with an initial cost of $11,000, a salvage value of 1,000 and a recovery period of 5 yrs for A. straight line depreciation. B. Double declining balance. C. MACRS?
What are the adjusted elevations for benchmarks b c and d : Differential leveling between benchmarks A,B,C,D, and A gives elevation differences(m) of -15.632, 32.458, 38.214, and -55.025, and distances(km) of 4,6,5, and 3 respectively.
What nominal annual interest rate effective annual interest : A store charges 1.25 % interest per month in credit purchases. This is equivalent to: what nominal annual interest rate, effective annual interest rate, and effective monthly interest rate?
Which alternative would be better if the equipment : A firm is deciding wheter to buy or rent equipment. How many days would they need to use the equipment each year to justify purchasing the equipment? To purchase equipmet/ Buy at $60,000

Reviews

Write a Review

Civil Engineering Questions & Answers

  Percentage of kinetic energy

In what direction did the cue ball move after the collision? What percentage of its kinetic energy did the cue ball impart to the eight ball?

  Develop a simple urban constructed wetland design

develop a simple urban constructed wetland design guidelines and drawings. your report should include the followingi.

  What is the permeability of the soil specimen in cm per sec

The diameter of the soil column is 8.0 cm, the length of the soil column is 16.0 cm. The hydraulic head loss across the soil specimen is 6.4 cm. Over a period of 3 min, 350 mL of water is collected at the downstream side of the soil specimen.

  Compute minimum footing width required to maintain safety

a bearing wall carries a dead load of 120kn/m and live load of 100 kn/m. It is to be supported on a 400mm deep continuous footing underlain by a medium sand (unit weight = 19.2 kn/m3, phi= 37 deg, effective c = 0).

  Determine the mean effective pressure of an ideal otto cycle

At the beginning of compression the pressure is 14 psi and the temperature if 60°F. The temperature at the end of combustion heat addition is 1500°F and the compression ratio is 9. Use constant specific heats at room temperature

  Find method to compute the flexural stresses for the load

Assume the section has cracked and use the transformed area method to compute their flexural stresses for the load. Given: Beam 30 ft long with uniform load of 2 k/ft and a point load of 30 k at 10 ft.

  Calculate how many lbs of co2 are produced per gallon

Diesel fuel has an average chemical formula of C12H23 and a density of 6.45 lb/gal. Calculate how many lbs of CO2 are produced per gallon of diesel burned (assume complete combustion).

  What are the annual runoff coefficient for the sub areas

What are the annual runoff coefficient (Runoff /Rainfall ratio) for the sub areas and for the total watershed taken as whole Sub-area Area (m2)/ Annual Precipitation (mm)/ Annual Evaporation (mm) A 10.7 1030 530 B 3.0 830 438 C 8.2 900 430 D 17...

  What is the angle of inclination of the plane

A body slides down a frictionless plane and during the third second after starting from rest if it travels 20.4m. What is the angle of inclination of the plane?

  How many years will it take to uniformly corrode a thickness

A galvanized (zinc-coated) steel sheet is found to uniformly corrode with an average current density of 1.4 X 10-7 A/cm2. How many years will it take to uniformly corrode a thickness of 0.030 mm of the zinc coating?

  Estimate the elastic modulus of the frozen artery

Properties of frozen tissues have been measured as part of understanding the response of tissue to cryopreservation. In one set of experiments, frozen bovine carotid arteries were tested in uniaxial tension.

  Determining maximum acceleration and maximum velocity

The posItIon of a particle along a straight line is given by s = (t 3 - 9t 2 + 1St) ft, where t is in seconds. Determine its maximum acceleration and maximum velocity during the time interval 0 :5: t :5: 10 s.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd