Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A clean-earth channel, for which n=0.020, is 6m wide and lies on a slope of 0.005236. Water flows at 30m3/s through the channel and enters a reservoir. The water depth in the channel, just before the entry to reservoir, is 3m.
a) Determine the uniform depth in the channel.
b) Determine the critical depth in the channel.
c) Sketch the backwater curves for the channel.
d) Calculate the distance upstream from the point of entry to the reservoir at which the water depth is 2m?
A rectangular channel 5 m wide carries a discharge of 10 m^3/s at a uniform depth of 3 m. The channel is running on a slope of 0.0025 m/m. Estimate wall shear stress and friction velocity. Assume the density of flowing water as 1000 kg/m^3.
a rectangular clarifier with a length:width ratio of 3:1 receives a flow of 850m3/day. the clarifiers depth is 4.0m and the detention time of the water inthe clarifier is 2.4 hrs, what are the surface overflow rate and the horizontal flow through ..
How do the concepts of green design, industrial ecology, and sustainable developement differ from past approaches to engineering design Prepare a brief report on this topic using some specific examples for illustration.
Calculate the overall modulus of the composite, explaining your calculations and the assumptions you have made when it is loaded:
that acts at a 45 degree angle from the side of the footing (it acts diagonally across the top of the footing) determine whether the resultant force acts within the kern. If it does, then compute the bearing pressure at each corner of the footing.
A pre- engineering base line was run down a very steep hill.rather than measure horizontaily down hill with steel tape: surveyor measured the vertical angle with the theodolite and slope distance with 16m steel tape.
The average rate of flow measured in a gage at the outlet of the watershed was 30 m^3/sec. Estimate the water losses due to the combined effects of evaporation, transpiration, and infiltration due to ground water.
What does under-reinforced mean Which is desirable and why How would your Moment-Curvature plot be affected if the amount of tension steel was doubled How would your Moment-Curvature plot from part a be affected if compression steel was added to the..
A solid circular shaft AC of total length L=L1+L2 is fixed against rotation at ends A and C and is loaded by a tourqe T_b at joint B. If the diameter of the two segements of the shaft are in ratio d2/d1
At an axial load of 23 kN, a 40-mm-wide by 10-mm-thick polyimide polymer bar elongates 2.7 mm while the bar width contracts 0.17 mm. The bar is 240 mm long. At the 23-kN load, the stress in the polymer bar is less than its proportional limit.
Draw the FBD and the shear and bending moment diagrams. Label all minimums, maximums and zero crossing points as well as the slopes as constant, linear or parabolic.
The 30-Mg freight car A and 20-Mg freight car are moving towards each other with the velocities of VA= 20km/h and VB=10 km/h. A spring mounted on A has k=3 MN/m Determine the maximum compression of the spring mounted on car A.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd