Calculate the diode current

Assignment Help Electrical Engineering
Reference no: EM13219236

An ideal p-n junction diode has saturation current Is = 3e-15 A. Calculate the diode current when a

(a) forward bias of 0.9 V is applied and

(b) a reverse bias of -0.9 V is applied. Hint: at room temperature (k*T/q = 0.026 V)

Reference no: EM13219236

Questions Cloud

What is the value of the smallest resistor : The voltage drops across three resistors in series are measured 10V, 15V, and 25V. If the largest resistor is 47 ohms, what is the value of the smallest resistor?
What is the total number of electrons transported : What is the total number of electrons transported from the positive electrode to the negative electrode by the charge escalator from the time the battery is first used until it is completely dead?
Explain what is the corresponding implied forward rate : According to the pure expectations theory of interest rates, how much do you expect to pay for a one-year STRIPS on February 15, 2011? What is the corresponding implied forward rate
Determine the best strategy for the company : Construct the appropriate decision tree to help the oil company make the appropriate decisions. This tree must be constructed in logical order with labels and net payoffs. It also includes the revised probabilities
Calculate the diode current : An ideal p-n junction diode has saturation current Is = 3e-15 A. Calculate the diode current.
Make a fundamental financial analysis of the company : Prepare a fundamental financial analysis of the company IBM from its published financial statements of the annual report year 2013, submit an 8- to 10-page paper (excluding appendices, cover page, abstract, and references).
Find nd on n side : Built-in voltage for a Si p-n junction is tested to be 0.6 V, NA = 2 X 10^15 cm^-3 on p side. Find ND on n side. (Assume ni = 1 x 10^10 cm^-3; and k*T/q= 0.026 V)
Will ohsas pel be exceeded : A plant has two identical standby generator units for emergency power use. In the area of the generators, the normal noise level registers 81 dBA on the sound-level meter with the generators turned off. When one generator switches on, the noise le..
What happens to equilibrium price and quantity for products : E-books and the paper book versions of the same books are substitutes. Assume that copyright holders originally demand a higher price for e-books than for paperback books. Then they relent and allow publishers to sell e-books for a lower fee.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Compute the power absorbed by an element in a circuit

Compute the power absorbed by an element in a circuit, but for a simple sinusoidal current i = sin(2πt/T) where T = 1 s.

  What is the actual value of the irr on the incremental cost

a) Construct a choice table for interest rates from 0% to 100%. b) Which roof should you choose if your MARR is 12% what is the actual value of the IRR on the incremental cost?

  Find a possible series rl circuit equivalent to n

Find a possible series RL circuit equivalent to N.

  What current in amperes will flow through the bulbs

A 100 W bulb takes 0.833A and a 200 W bulb takes 1.67 A from a 120V source. If the two bulb were connected across a 240 V source, what current in amperes will flow through the bulbs?

  Write a program to genrate a square wave

assuming XTAL=11.0592 MHz,write a program to genrate a square wave of 20 Hz frequency on pin2.3?

  What is the steepest grade up

(a) What is the tension in the coupling between the first car and the locomotive? (b) If this tension is equal to the maximum force the locomotive can exert on the train, what is the steepest grade up which the locomotive can pull the train at 25 ..

  Calculate the current in the output of the source

Calculate the current in the output of the source before and after the installation of the new device and The temperature sensor output is a voltage which is equal to the temperature sensed by the sensor. Design an electric circuit which can get th..

  Compute the diameter in centimeters of a steel rod

compute the diameter in centimeters of a steel rod, an aluminum rod, and a copper rod, which can withstand a particular compression load.

  Determine power series values

Determine power series values for common scientific and engineering functions and Obtain the Maclaurin series for the following functions. State the values of the x which the series converge.

  What is the maximum symbol rate which can be sent over link

What is the maximum symbol rate which can be sent over this link? If a binary line code is used, what is the maximum bit rate? What is the maximum bit rate with 4-ASK symbols?

  Write an assembly code segment that calls the subroutine

Write an assembly code segment that calls the subroutine New Function if bits 5 and 6 of PORTD equal 1. Write the same code segment in part (a) using structured assembly constructs.

  Non-feedback- four-character combinations

Assuming no feedback to the adversary until each attempt has been completed, what is the expected time to discover the correct password?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd