Calculate the detention time in hours horizontal velocity

Assignment Help Civil Engineering
Reference no: EM13535620

Two rectangular clarifiers(sedimentation basins), each 30 ft long, 15 ft wide, and 10ft deep, settle a combinedtotal of 0.40 mgd following alum coagulation. The effluent channelshave a total weir length of 60ft in each basin. Calculate the detention time (in hours),horizontal velocity of flow (ft/min), and rate offlow over the outlet weir (weir loading, in gpd/ft).

Reference no: EM13535620

Questions Cloud

Determine the net power delivered and the cycle efficiency : Determine the net power delivered and the cycle efficiency. What is the percent increase in the efficiency compared to an otherwise identical system with no regeneration. Assume “cold air-standard cycle” for both systems above.
What are the heat addition rate in the combuster and the : A “Cold Air-Standard Brayton cycle” gas-turbine power plant delivers a net power output of 60 MW to an electric generator. The compressor intake temperature is 300 K and the maximum temperature in the cycle is 1200 K.
What is the diameter of the bubble before it reaches : Listed on cramster as ask. There is a car driving through water. Velocity is 12mph. Find h (max water depth) that will alow car to pass. List all assumption and calculations is the problem statement.
Calculate the minimum required cross-sectional area : The moduli of elasticity of plain concrete and steal are 25 GPa and 207GPa respectively, and the corss-sectionial area of steel is 2% of that of the reinforced concrete.
Calculate the detention time in hours horizontal velocity : Two rectangular clarifiers(sedimentation basins), each 30 ft long, 15 ft wide, and 10ft deep, settle a combinedtotal of 0.40 mgd following alum coagulation. The effluent channelshave a total weir length of 60ft in each basin
The angle theta which the 6-lb. uniform rod makes with the v : A 5-lb force is applied to the center of the roller at A, causing the assembly to roll. If the roller has negligible mass, determine (a) the angle theta which the 6-lb. uniform rod makes with the vertical during the roll, and
Select the beam dimensions and reinforcement for a balanced : A rectangular concrete beam has f'c=3000 psi and steel with fy=40ksi. Select the beam dimensions and reinforcement for a balanced section if the beam sustains a moment as a result of dead load of 60 kip-ft and a moment as a result of live load of 90 ..
Estimate the discharge rate of the pipeline : Reservoir A (water surface elevation = 1300 ft) is connected to reservoir B (water surface elevation=250 ft) by 6,000 ft of 14 inch diameter cast iron pipe (e = 0.005 ft. Neglecting all minor losses
Include a sketch of each cross-section drawn to scale : Problem Statement: A singly reinforced rectangular beam is to be designed, with effective depth approximately 1.5 times the width, to carry a service live load of 2000 lb/ft in addition to its own weight, on a 24 ft simple span. The ACI Code load fac..

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the biomass concentration in the aeration tank

average flow rate = .0022 m^3 /s (190 m^3 /d) Influent Substrate concentration = 250 mg/L as COD (all essentially soluble) Mean cell residence time is to be 5 days Volume of mix tank = 25 m^3 the reactors kenetic constants are

  Compute the amount of chlorine required for disinfection

Compute the amount of chlorine required for disinfection in pounds per day(lb/d). Estimate the annual cost for disinfection using chlorine. Flow Rate= 30 milloin gallons per day.

  Determine internal shear and moment at specified location

Write a computer program that can be used to determine the internal shear and moment at any specified location x along the beam, and plot the shear and moment diagrams for the beam.

  Determine the hydraulic conductivity of an artesian aquifer

An experiment was conducted to determine the hydraulic conductivity of an artesian aquifer. The piezometric heads at two points 150m apart were found to be 55 m and 48.5 m above a datum.

  Determine the length of time

The 20-lb cart B is supported on rollers of negligible size. If a 10-lb suitcase A is thrown horizontally on it at 10 ft/s, determine the length of time that A slides relative to B, and the final velocity of A and B. The coefficient of kinetic fri..

  Determine the depth of flow and the discharge immediately

A tidal channel, which may be assumed to be rectangular, is 40 m wide and conveys a discharge of 60 m3/s at a depth of 1.52 m. A tidal bore is seen to propagate upstream with a wave speed of 5 m/s.

  Find what is the minimum distance from the stalled car

The road is in good condition and is initially dry, but it becomes wet 160 ft before the stalled car (and stays wet until the car is reached). What is the minimum distance from the stalled car at which the driver could apply the brakes and still s..

  Does our non-destructive test have the required sensitivity

To be sure that the part does not fail, we plan to ensure that the maximum applied stress is only one third of the tensile strength. We use a non-destructive test that will detect any internal flaws greater than 1.25 mm long.

  Calculate the drawdown

Calculate the drawdown at the well (use r which is the distance from the pumping well = 18 in) with total withdrawals from storage after (a) 1 min, (b) 1 h, (c) 1 day, (d) 1 month, and (e) 1 yr of continuous pumping, at design capacity.

  Which alternative is inferior in the ford costs for two year

investing in the General Motors costs $10,000 today and pays back $11,500 two years from now. If investing in the Ford costs $8,000 today and pays back $4,500 each year for two years, which alternative is inferior

  Determine concentrations of a and b at outlet of reactor

A fluid flows into a plug flow reactor of volume, V, with volumetric flow rate, Q. Inflow contains species A and B and concentrations A0 and B0. Within reactor, species A undergoes first order reaction producing B... R=k[A].

  Determine the degree of saturation of a sample of soil

Determine the degree of saturation of a sample of soil given that its maximum dry unit weight is 18 kN/m^3 and its optimum moisture content is 12.1%. Assume the Specific Gravity of soil is 2.65.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd