Calculate the density of air flow ate sections 1 and 2

Assignment Help Civil Engineering
Reference no: EM13306187

Air flows steadily between two sections in a long, straight portion of 4 in. inside diameter pipe (D1=D2). The uniformly distributed temperature and pressure at each section are p1=100psia, p2=18.4psia, T1=540 R and T2=453 R. The average velocity air velocity (nonuniform velocity distribution) at section 2 is 1000ft/s (V2=1000ft/s). A) Calculate the density of air flow ate sections 1 and 2. B) calculate the mass flux through section 1.

Reference no: EM13306187

Questions Cloud

What fraction of the original dose remains in the body : Tetchnetium is a radioactive isotope that emits a gamma ray with a half life of 6 hours. what fraction of the original dose remains in the body 24 hours after preparation
Determine how many days per year would have to operate : A contractor is considering the purchase of an earthmover to avoid the cost of a rental unit. The earthmover costs $350,000 initially and will cost $7000 per year to store and maintain.
What is the frequency of ubv photons : UVB photons have a wavelenghth of 300nm. what is the frequency of UBV photons, What is the energy of a UBV photon in JOULES
What is the network address of the first network : Using slash notation, what is the network address of the first network?
Calculate the density of air flow ate sections 1 and 2 : Air flows steadily between two sections in a long, straight portion of 4 in. inside diameter pipe (D1=D2). The uniformly distributed temperature and pressure at each section are p1=100psia, p2=18.4psia, T1=540 R and T2=453 R.
Draw internal shear force and bending moment for the beam : The overhang beam has been fabricated with a projected arm BD on it. Draw the internal shear force, bending moment, and normal force diagrams for the beam ABC if it supports a load of 800 lb.
Create a visual basic program : Create a Visual Basic program that creates a bill for an automobile repair shop. The shop bills customers at the rate of $35 per hour for labor. Parts and supplies are subject to a 5% sales tax.
Determine the change in entropy due to this heat transfer : How much heat flows from 1.0 kg of water at 40.0 degrees C when it is placed in contact with 1.0 kg of 16.0 degrees C water in reaching equilibrium, what is the change in entropy due to this heat transfer
The answer should indicate will these values increase : What will happen to Y (GDP), r (real interest rate), P(price level), and I(investment), in the short run ?The answer should indicate will these values increase or decrease in the short run.

Reviews

Write a Review

Civil Engineering Questions & Answers

  How long ago did the dumping stop

the flow rate into the lake is 10 m3/s, the surface area of the lake is 1 x 107 m2, and the rate of evaporation from the lake is 6 cm/wk, how long ago did the dumping stop?

  Determine the normal depth in a trapezoidal channel

Determine the normal depth in a trapezoidal channel with a bottom width of 6.4 ft and side slopes of 1 vertical to 2 horizontal. The discharge is 85 ft3/s. Manning's roughness factor is 0.025 and the channel bottom slope is 0.001

  Briefly describe the measures

Briefly describe the measures that should be considered for the control of corrosion of embedded steel in concrete.

  What is the permeability of the soil specimen in cm per sec

The diameter of the soil column is 8.0 cm, the length of the soil column is 16.0 cm. The hydraulic head loss across the soil specimen is 6.4 cm. Over a period of 3 min, 350 mL of water is collected at the downstream side of the soil specimen.

  What percent removal of organic matter

If the BOD5 of the river below the mill outfall must not exceed 5 mg/L, what percent removal of organic matter (BOD5) is required by the mill to meet this requirement?

  Consolidation ratio of the soil at the unloaded condition

An increment of vertical stress of150kpa compress the sample to a void ratio of1.43. What is the over consolidation ratio of the soil at the unloaded condition.

  Find the location-velocity and acceleration of a box

The motion of a box on a spiral conveyor is defined by the following position vector: r = 0.5sin(2t) i + 0.5cos(2t) j - 0.2t k where r is in meters and t is in seconds. Find the location, velocity, and acceleration when t = 0.8 s.

  What is the probability that a random sample

What is the probability that a random sample of 20 time intervals between eruptions has a mean longer than 95 minutes?

  Define the problem to be researched

When Eurasia restaurant, serving Eurasian cuisine, first opened along Chicago's Michigan Avenue, its novelty brought many diners.

  Design the ramp for the highest horizontal curve

The entrance to Mt. Hood Meadows (elevation 3,075 ft at the point of crossing) is grade separated from Viking highway (elevation 3,050 ft at the point of crossing) and will have to be connected. The two roadways intersect at a right angle.

  Calculate the moment of inertia for the milkyway

calculate the moment of inertia for the Milkyway. Assume it to be a disk.

  Find residual chemical concentration and amount of chemical

A chemical is added at the beginning of a water treatment plant at a dose of 750 lb/day. The water treatment plant provides water to a community of 200,000 people and the average water consumption in the city is 110 gallons per capita per day (gpc..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd