Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Problem: A moist sample has a total density of 2040kg/m^3, water content of 20%, and specific gravity of solids (Gs) of 2.65
Required:
Question 1: Calculate the degree of saturation
Question 2: If the total mass of the sample if 600g, calculate the volume of voids.
Question 3: Calculate the volume of water to be removed, for the new water content to be 10%
A fireworks shell is launched vertically from point A with speed sufficient to reach a maximum altitude of 500ft. A steady horizontal wind causes a constant horizontal acceleration of 0.5ft/sec^2, but does not affect the vertical motion.
The velocity distribution for the flow of oil (SAE 20W) at 150 degrees between two plates is given by y(y-4) mm/s, where y is measured in mm and the space between the plates is 4mm. Determine the shear stress at each wall and the maximum shear str..
An ideal gas refrigeration cycle using air as the working fluid operates between the pressure limits of 80 and 280 kPa. Air is cooled to 35°C before entering the turbine.
The speed of sound in liquid water at 25?C is about 1500 m/s. Find the stagnation pressure and temperature for a M = 0.1 flow at 25?C, 100 kPa. Is it possible to get a significant Mach number flow of liquid water?
To study mixing of the stream and river, a conservative tracer is to be added to Tin Pot Run. If the instruments that measure the tracer can detect a concentration of 1.0 mg/L, what minimum concentration must be achieved
The cylindrical wall of the tank is 6mm thick, has a 600mm inside diameter, and is made of steel with E = 200 GPa and v = 0.30. Determine the pressure in the tank indicated by a strain gage reading of 280*10^-6 in/in.
The magnetic bearing of a boundary line was recorded as N 35°00 W in a deed dated 1903. At that time and place, the magnetic declination was known to be 3°15 W. Determine the true azimuth and bearing for the line.
What is the normal depth in a 4-foot wide rectangular channel that conveys a discharge of 100 CFS and has a bed slope of 2% with a Manning’s roughness coefficient of 0.025? a).1.3 feet b).2.7 feet c).4.4 feet d).6.2 feet
Briefly explain the difference between piezometer and tensiometer with respect to the working principle, special design consideration and limitation of the instrument.
The relative density of a sloped sand deposit is known to be 75%. Water is observed to be seeped through this slope at a rate such that the discharge velocity is 0.6 m/day. If the hydraulic conductivity for this deposit is 4×10-4 m/s.
Consider a 1000-W iron whose base plate is made of 0.5 cm thick aluminum alloy 2024-T6 (density = 2770 kg/m^3 and c(p)=875 J/kg C). The base plate has a surface area of 0.03 m^2.
Why should barrier wall EIFS be avoided?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd