User Account

All Pages

Calculate the deflection at the extremes

Assignment Help Civil Engineering
Reference no: EM131344429

A bimetallic strip is to be constructed of yellow brass and Invar for the purpose of measuring temperature over the range from -10?C to 120?C. The length of the strip is 2.5 cm and each sheet has a thickness of 0.3 mm. Assuming that the strip is bonded at 30?C, calculate the deflection at the extremes of the design temperature range.

Reference no: EM131344429

Questions Cloud

Calculate the flow-stream temperature : The plate temperature is measured as 100?C, ±0.5?C, and the room temperature surrounding the plate is at 20?C, ±0.5?C. Using emissivity data from the appendix, calculate the flow-stream temperature and estimate its uncertainty.
Calculate the equilibrium level of income : Calculate the equilibrium level of Income and the interest rate. Describe your solution with a graph. Calculate the equilibrium level of consumption and investment
How does the energy of the s-bonding mo of h2 : 1) Sketch the unoccupied MO of the H2+ ion. Does this orbital have a node?  If yes, sketch and describe the surface. 2) How does the energy of the s-bonding MO of H2+compare to that of the 1s orbital of hydrogen ?
Calculate the change in fluid power : A turbine used for hydroelectric power generation has a total head of 86 m at the turbine inlet and 4.6 m at the turbine outlet. If 1.7 m3/s of water flow through the turbine, calculate the change in fluid power.
Calculate the deflection at the extremes : The length of the strip is 2.5 cm and each sheet has a thickness of 0.3 mm. Assuming that the strip is bonded at 30?C, calculate the deflection at the extremes of the design temperature range.
Advertising and promotional strategy : How many are there in the areas you are going to service - How will you address their strengths and capitalise on their weaknesses
What are fermions and bosons : What are fermions and bosons? What is the difference between the two classifications?
Write the given quadratic function : Write the following quadratic function in the form f(x)=a(x-h)^2+k. Then, give the vertex of its graph. Finally, graph the function by plotting the vertex and four additional points, two on each side of the vertex.
Calculate the free-stream temperature and the uncertainty : The thermocouple installed in the probe is accurate within ±1.0?C and indicates a temperature of 380?C. Calculate the free-stream temperature and the uncertainty.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the change in the entropy to be reversible process

Air mass of 4 kg of liquid water is cooled from 90c to 10c under a constant pressure. Determine the change in its entropy, assuming the process to be reversible.

  Discuss if you are going or not to stabilize the slope –why

Given that that there is no budget to built any type of artificial protection enclosure or retention wall but you still have some allowance for using earthmoving equipment, which of the techniques discussed in class would appropriate in case slope pr..

  Find final temperature-specific work and specific heat

a piston/cylinder contains liquid water at 2 degrees Celcius, with a freely moving piston maintains a pressure of 200 kPa on the water. Heat transfers to the liquid water until the piston/cylinder contains only saturated vapor.

  Compute and tabulate the bearings of the sides of a regular

Compute and tabulate the bearingsof the sides of a regular pentagon (polygon with five equalangles), given the starting direction of sideAB.

  Helium gas is compressed is entropically from 1 bar and 25 c

Helium gas is compressed isentropically from 1 bar and 25 C to a pressure of 10 bar. The temperature of Helium after the compression is A) 25 C B) 63 C C) 250 C D) 384 C E) 476 C

  What is the elevation of the tip of the spire

The telescope of the instrument is 5.25 ft above the ground station, whose elevation is 415.65 ft. What is the elevation of the tip of the spire? (Ignore atmospheric refraction and earth curvature)

  Calculate the head loss when the oil is at 80 degree f

A 10 inch steel pipeline 100 feet long carriers 2000 gpm of crude oil. Calculate the head loss when the oil is at a) 80 degree F b) 110 degree F.

  Discuss how relative motion is critical issue in the midair

Discuss how relative motion is a critical issue in the midair refueling of aircraft. Would control of this process be with the pilot of the tanker or the aircraft being refueled

  In which water is sprayed directly into the exhaust duct

The exhaust from a rotary kiln hazardous waste incinerator must be cooled from 1200 degrees C to 300 degrees C before entering a spray dryer for acid gas removal.

  Calculate the mass flux rate and the flow rate

Water is flowing in a 6-cm diameter pipe at 20 m/s at 10?C. If the pipe enlarges to a diameter of 12-cm, calculate the reduced velocity. Also, calculate the mass flux rate and the flow rate.

  Draw a state-transition diagram for an fsm

Draw the state-transition diagram for a deterministic FSM that recognizes the strings AI(AB). Take care not to accept any other strings, such as ABB.

  Find the flow rate of air and the second-law efficiency

A condenser is maintained at 60?C by cooling it with atmospheric air coming in at 20?C and leaving at 35?C. The condenser must reject 25 MW from the water to the air. Find the flow rate of air and the second-law efficiency of the heat exchanger.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd