Reference no: EM13293019
1 An air-filled rectangular waveguide has a cross section of 6 X 4 an.
(a) Calculate the cutoff frequency of the dominant mode.
(b) Determine how many modes are passed at three times cutoff frequency of dominant mode.
2 An air-filled waveguide has a = 6 cm and b = 4 cm. What modes are possible if a wave of frequency f = 6 GHz is to be propagated down the guide?
3 A rectangular waveguide (2.28 X 1.01 cm) is filled with polyethylene (εr = 2.25). Calculate the cutoff frequencies for the following modes:
Molt TE10, TE11, TE02, TE22, TM11, TM12, TM21. Assume that polyethylene is lossless.
4 A 2 X 1 cm waveguide is filled with deionized water with e, = 81. If the operating frequency is 4.5 GHz, determine (a) all possible propagating modes and their cutoff frequencies, (b) the intrinsic impedance of the highest mode, (c) the group velocity of the lowest mode.
5 Design a rectangular waveguide with an aspect ratio of 3 to 1 for use in the K band (18-26.5 GHz). Assume that the guide is air filled.
6 A tunnel is modeled as an air-filled metallic rectangular waveguide with dimensions a = 8 m and b16 m. Determine whether the tunnel %till pass (a) a 1.5 wiz AM broadcast signal, (b) a 120 MHz FM broadcast signal.
12.7 In an air-filled rectangular waveguide, the cutoff frequency of a TE10 mode is 5 GHz whereas that of TE0, mode is 12 GHz. Calculate
(a) The dimensions of the guide
(b) The cutoff frequencies of the next three higher TE modes
Attachment:- Question.png
|
Compute the charge must be on each plate
: An electric field of 7.85 105 V/m is desired between two parallel plates, each of area 38.0 cm2, What charge must be on each plate
|
|
Draw the circuit and discuss the operation of sa type adc
: Draw the circuit and discuss the operation of SA type ADC. Determine the conversion time of an SA-ADC for 12-bit resolution,at 2.5 MHz.
|
|
Explain a standard galvanic cell the half-reactions
: If you built a standard galvanic cell using the following half-reactions, what is the maximum work that could be done by this standard cell? (deltaG=wmax)
|
|
Explain the benefits and risks of debt financing
: If Touring Enterprises were to increase the percentage of debt in its capital structure, what would happen to the WACC ? No calculation is necessary- simply provide a short, non-numeric response.
|
|
Calculate the cutoff frequency of the dominant mode
: Calculate the cutoff frequency of the dominant mode and determine how many modes are passed at three times cutoff frequency of dominant mode and calculate the cutoff frequency of the dominant mode
|
|
Find the magnetic field at the center of this loop
: A circular loop of wire with 10 turns, radius 0.241 m and resistance 0.235 Ohms is connected to a 13.1 V power supply. find The magnetic field at the center of this loop
|
|
Compute peak value of rms output voltage and power
: a Three phase to single phase converter employs a 6 pulse bridge circuit. This device is fed from 400V,50 Hz supply through adelta/stare transformer whose per phase turns ratio 3:1. For an output frequency of 2Hz, the load reactance is w0L =3ohm.
|
|
Which capital budgeting method is most useful for evaluating
: Which capital budgeting method is most useful for evaluating the following project?
|
|
What are the ideal and minimum possible temperatures
: A temperature transmitter has an input range of 0 to 100 degrees celsius, an output range of 4 to 20 mA, and anaccuracy of ± 0.5%. The ideal transmitter has a linear output from 4 mA at 0 degrees celsius to 20 mA at 100 degrees celsius.
|