Reference no: EM131076852
1. The diagram of FIGURE I represents a meter shunted by a parallel resistance Rs.
(a) Determine the required value of the shunt resistance if the maximum value of the current / is 200 A. The meter can read a maximum of 1 mA and has a resistance of 0.1 11.
(b) If the shunt is made of copper and has a cross-sectional area of 25 cm2 calculate its required length. (For copper take p as 1.7 x 10-812m.)
2. The circuit of FIGURE 2 shows a 10 kit potentiometer with a 5 Ica load. Determine the position of the slider on the 9V /OM 'pot' when the voltage across points 'XX' is 3 V. 5 *0
3. (a) Calculate the value of the current through the 12 V battery shown in FIGURE 3.
(b) Calculate the power dissipated in RI, R2 and R.
4. If the magnetic flux linking all the turns of a 50 turn coil changes from 10 mWb to 20 mWb and induces an e.m.f. of 62.5 V in the coil, calculate the time over which the flux changes.
5. A 500 mm conductor inside an electric motor has a force of 1.5 newtons exerted on it. If it is at right angles to a magnetic field of flux density 0.6 T, calculate the current flowing in the conductor.
6. FIGURE 4 show the construction of a multi-plate variable capacitor having 4 pairs of plates. The plates, when closed, are separated in air by 0.01 mm and a capacitance range of 10 to 400 pF is required.
(a) Estimate the required radius, R, of each plate.
(b) The capacitor is set to the maximum 400 pF and is charged to 10 V through a 50 kit resistor. Determine:
(i) the initial value of current flowing.
(ii) the time constant for the circuit.
(c) Having fully charged, the capacitor is then discharged through the 50 1d1 resistor. Determine:
(i) the current flowing when the capacitor has been discharging for 5 ;is
(ii) the voltage drop across the resistor when the capacitor has been discharging for 10 Rs.
7. An inductor of negligible resistance and an inductance of 0.2 H is connected in series with a 330 a resistor to a 12V d.c. supply. Determine:
(a) the time constant of the circuit
(b) the voltage drop across the inductor after two time constants
(c) the voltage drop across the resistor after three time constants
(d) the resistance of a 0.2 H coil used to replace the inductor if the circuit's time constant falls to 0.55 ms.
|
Rate of heat loss in watts due to process
: Even if a man shows no visible perspiration he still evaporates about 500 grams of water per day from his lungs. How many calories of heat are removed by this evaporation? What is the rate of heat loss in watts due to this process?
|
|
What is the order of the bucket sort
: What is the order of the bucket sort? Why is the bucket sort not useful as a general sorting algorithm?
|
|
What is impact of this inward fdi on the real wage of labor
: What is the impact of this inward FDI on the real wage of labor, the real rental of capital, and the real rental of land in Home? How does the outward investment affect the real earnings of labor in Foreign?
|
|
Power of the cicada sound source
: Estimate how far away a cicada can be heard if the lowest possible audible intensity of a sound it produces is 9 × 10^-10 W/m2 and the power of the cicada's sound source is 3 × 10^-6 W.
|
|
Calculate the current flowing in the conductor
: (a) Determine the required value of the shunt resistance if the maximum value of the current / is 200 A. The meter can read a maximum of 1 mA and has a resistance of 0.1 11.
|
|
Find one of evidence showing that nature makes contribution
: Try to choose evidence that has not been previously discussed by one of your classmates. Describe each of these pieces of evidence and explain why it supports the influence of either nature or nurture, as appropriate. What is the practical importa..
|
|
Minimum pulling force
: He pulls vertically downward on a rope that passes around three pulleys and is tied around his feet. What is the minimum pulling force that the clown must exert to yank his feet out from under himself?
|
|
Do the recursive calls to merge sort depend on the values
: In what step of merge Sort are the items in the array actually swapped (that is, sorted)? Explain
|
|
Problem regarding the minimum dish diameter
: The system must be capable of resolving two aircraft that are separated by 1.00 mile at a distance of 20 miles from the airport. Assuming the receiving dish is circular, what minimum dish diameter is required?
|