Calculate the current components in npn transistor

Assignment Help Electrical Engineering
Reference no: EM13246797

A silicon p-n-p transistor has impurity concentrations of 5*10^18, 2*10^17, and 10^16 cm^-3, diffusion constants of minority carriers 52, 40, and 115 cm^2/s and minority lifetimes of 10^-8, 10^-7, and 10^-6 in the emitter, base, and collector, respectively. If the base width is 1*10^-6 m, the device cross-sectional area is 0.2 mm^2, and the emitter-base junction is forward bias to 0.5 V, calculate the current components \(I_{Ep}, I _{Cp}, I_{En}, I_{Cn}, and I_{BB}\)

Reference no: EM13246797

Questions Cloud

Determine the surface charge density : An air-filled capacitor consists of two parallel plates, each with an area of 7.60 cm2, separated by a distance of 1.60 mm. An air-filled capacitor consists of two parallel plates, each with an area of 7.60 cm2, separated by a distance of 1.60 mm.
Centralized political power was a characteristic of paleo : Centralized political power was a characteristic of the Paleo-Indians. Martin van Buren would have won the nomination for president on the first ballot at the Democratic convention in 1844 were it not for the Party's two-thirds rule
Explain iron nitrate reacts in solution : What is the mass (in grams) of the precipitate when 7.32 g of iron(II) nitrate reacts in solution with excess sodium carbonate
Second wave feminist movements : Compare the tactics used by the activists in How to Survive a Plague to those used by the civil rights and second wave feminist movements.
Calculate the current components in npn transistor : A silicon p-n-p transistor has impurity concentrations of 5*10^18, 2*10^17, and 10^16 cm^-3, diffusion constants of minority carriers 52, 40, and 115 cm^2/s and minority lifetimes of 10^-8, 10^-7, and 10^-6 in the emitter
Determine the internal resistance of the battery : A 1.57-? resistor is connected across a 6.90-V battery. The voltage between the terminals of the battery is observed to be only 6.30 V
Compute the value of e for the cell of operation stage : calculate the value for E for the cell at 25oC (b) A current is drawn from the cell until 1.20 g of silver have been deposited at the silver electrode. Calculate the value of E for the cell at that stage of operation.
The federal government and federal court actions : The federal government and federal court actions had a significant impact on the rights and status of African Americans, Mexican Americans, and Native Americans during the 1950s.
Determine the cone angle that will match the line : (a) Determine the cone angle that will match the line to an infinite length biconical antenna. (b) For the cone angle of part (a), determine the two smallest cone lengths that will resonate the antenna.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define write-back write allocate

How do we deal with a L1 cache that is Write-back Write allocate, and the L2 cache, which is a Write-through Write no-allocate?

  Give the solution to power factor

The solution to Power Factor, Two single-phase loads are connected in parallel across a 415 V, 50 Hz supply. One load is rated 130 kW at a power factor of 0.75

  What local oscillator frequency would you use

For the local oscillator you selected, what transmission frequencies could cause interference to the satellite system and how could the interference be avoided? Show a diagram.

  Explain what would be the final elevation in m

an object hose mass is 200 kg moves at a velocity of 50m/sec and altitude of 200m,both measuredc relative to the surface of the earth. the acceleration of gravity can be taken as constant at g=9.8 m/sq.sec.

  Report changes on primavera

Can you write a part of project which is about developing a schedule of power substation on primavera (P6), focusing on the Changes that will happen based on the following:

  What is the effect of a frequency difference

What is the effect of a frequency difference between the carrier and local oscillator on output quality? Show mathematically.

  Define a design of a series controller

Design a series controller (a PD, PI or PID) so that the following performance specifications are satisfied. Steady-state error due to a step input = 0

  What is the saturation current and surface leakage current

A silicon diode has a reverse current of 5 uA and 25 degrees celcius and 100uA at 100 degrees celcius. What is the saturation current and surface leakage current at 25 degrees celcius

  Find speed of an electron beam coming from an electron gun

The axis of the cylinder is along the z axis, and the electrons are moving with a velocity vector v in the positive z direction. The velocity of the electrons is 0.1c where c is the speed of light (2.99792458 ´ 108 [m/s]). The magnitude of the cur..

  Explain how to create an array

Create an array, array1, that has the last 14 elements of which the first element is 49 and the last element is 10. THen using the colon symbol create a new array, array 2, whcih has 8 elements. the first 4 elements of array 2 are the 4th through ..

  Determine the electric field at all points in space

Point charges of 5nC and -2nC are located at (2,0,4) and (-3,0,5), respectively. A. Determine the electric field at all points in space. B. Determine the force on a 1nC point charge located at (1,-3,7).

  Calculate the free space loss-received power and fade margin

Perform a link budget for a 25-kilometer point-to-point microwave link in the 30 GHz band. Calculate the free space loss (dB), received power dBm), fade margin (dB), and Fresnel zone radius(m) given the following: Tx Power = 70 dBm

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd