Calculate the critical clearing angle

Assignment Help Electrical Engineering
Reference no: EM131324027

(1) A synchronous alternator is supplying 0.9 p.u. power to the grid when a temporary three-phase short occurs on the interconnector. The power angle curves are:-
Pre-fault = 2.0 sin(delta)
During fault = 0.5 sin(delta)
Post-fault = 1.4 sin(delta)
Calculate the critical clearing angle.

(2) A 400-km, 500 kV three-phase transmission line has a series impedance of z = 0.03 + j 0.35 ohms/km and a shunt admittance of y = j 4.4 x 10-6 S/km. Using the equivalent pi circuit calculate the sending end voltage, current and power factor when the line is delivering 1000 MW at unity power factor.

Repeat the calculation using nominal pi circuit and compare and comment upon the difference of the two calculations.

Reference no: EM131324027

Questions Cloud

Prepare a production cost worksheet : Direct materials are added at the beginning of the process. Conversion costs are incurred uniformly throughout the production process. Costing is handled on a FIFO basis. Prepare a production cost worksheet using 5 steps approach
Find the present value of the annuity : If she takes the $1.5 million, spends $700,000 of it, and invests the remainder at 7.2% compounded monthly, what amount will she receive at the end of each month for the next 40 years?
Create presentation of ideal performance management system : Create a presentation of an ideal performance management system that you would implement as the human resources manager of an organization.
Infection impact on fertility and pregnancy : How do you use research to gather compelling evidence for your public health issue?- How can you use data to prove that your issue is worthy of being a priority?
Calculate the critical clearing angle : A 400-km, 500 kV three-phase transmission line has a series impedance of z = 0.03 + j 0.35 ohms/km and a shunt admittance of y = j 4.4 x 10-6 S/km. Using the equivalent pi circuit calculate the sending end voltage, current and power factor when th..
What will the ram balance be at the end of year three : You have had a 30yr FA FRM at 10% for 5 years. The original principal was 1,000,000. You are considering a cash-out refi into a 15-year mortgage at 7.5%. The old mortgage has a prepay penalty of 3% if payoff occurs before year 8. What is the NPV of r..
Discuss the ethical theories of augustine and aquinas : What is one evident similarity and one marked difference between the ethical theories of Augustine and Aquinas?With which of these thinkers do you most agree (or disagree), and why?
List key ideas you have extracted from e-learning activity : List the key ideas you have extracted from the prescribed e-learning activity. Apply those ideas to your own experience, to an organisation you know and to the topic(s) of this subject - identify an organisation which would benefit from the applicati..
Explain the major privacy issues facing organizations today : Describe the major privacy issues facing organizations today. Analyze the major privacy issues described above and compare that to the potential privacy risks facing the sporting goods store.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the maximum power and torque

A 2,000-hp, unity power factor, three-phase, Y-connected, 2,300-V, 30-pole, 60-Hz syn chronous motor has a synchronous reactance of 1.95 Ω per phase. Neglect all losses. Find the maximum power and torque.

  Determine the error in temperature reading if noise is added

A temperature sensor produces 10 mV for each degree Fahrenheit. Determine the error in temperature reading if 20 mV of noise is added to the sensor output signal when the temperature is 70 degrees.

  Explain what is modified air-gap line withreference to occ

Elaborate the statement that an unloaded synchronous motor can be made to act as a capacitor or as an inductor.

  Find the gain kp necessary to meet requirements

A proportional control system is to be used to control the wing flaps of a jet air-plane. The wind load is expected to cause as much as 600 in .lb of torque. The system should be able to keep the flaps to within 5 of the set point.

  The formula for the carry bit

The formula for the carry bit

  How to minimize the number of inputs to the and gate

Using a 4-bit synchronous counter and an AND gate, construct a counter that counts from 0000 through 1010. Repeat for a count from 0000 through 1110. Minimize the number of inputs to the AND gate.

  Calculate the energy stored in the air gap of relay

A simple relay has an air gap of length 1.0mm and effective cross-sectional area of 1000mm2. The magnetising coilconsists of 1000 turns of wire carrying current of 200mA. Calculate the energy stored in the air gap.

  Find shortest distance from the load to location of the stub

A 100-Ohm lossless transmission line is to be matched to a load with impedance ZL = 120 - j80 Ohm using a short-circuited stub. Use the Smith chart to determine: (a) the standing wave ratio, (b) the shortest distance from the load to the location ..

  Determine primary nad secondary turns

The maximum flux density in the core of a 250/ 3000 volts, 50 Hz single phase transformer is 1.2 Wb/m2. if the emf per turn is 8 volt, determine (i) primary nad secondary turns (ii) area of the core

  What is the difference between dm and dpcm

In transform coding, when a sender transmits the M matrix to a receiver, does the sender need to send the T matrix used in calculation? Explain.

  Modify the state diagram branching conditions

Modify the state diagram branching conditions in the diagrams below as needed to ensure the sum and exclusion rules are obeyed in each case.

  Find the armature current

Find the armature current.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd