Calculate the cost of energy for the period 1947 to 1994

Assignment Help Electrical Engineering
Reference no: EM13276368

Construction on Hoover Dam was started in 1931 and finished in 1935, and the dam was in service from 1936. When completed, it was both the world's largest electric power producing facility and the world's largest concrete structure. It cost $165 million dollars to build (in 1935 dollars). The average annual net generation for Hoover Power plant for operating years 1947 through 1994 was about 4 billion kilowatt-hours. The operating cost during this period was 0.6 cents/kWhr (in 1990 dollars).
The interest rate charged to the project was low, "not exceeding 3%." Given these facts, answer the following questions related to the Hoover Dam for its operation up to 1994 when the loan was fully repaid.

a) Calculate the Cost of Energy (COE) for the period 1947 to 1994. Assume an average annual inflation rate of 3.5% for converting between present value and past value.

b) If the interest rate were to have been 1.5 percentage points above the original rate, calculate the COE for the same period.

c) i) Given that government backed projects are able to obtain financing at lower interest rates than purely private projects, can you comment on the importance of government involvement in such large infrastructure projects
ii) Why is the government able to get lower interest rates?
iii) By what mechanism does the government do this?
iv) who ultimately guarantees the loans?

Reference no: EM13276368

Questions Cloud

Explain the freezing point of pure water : When 0.60 grams of a molecular covalent compound is dissolved in 10 grams of water, the freezing point of the soludion is -1.86 C. Given that the freezing point of pure water is 0 C and that the freezing point depression constant for water is 1.85..
Determine the peak current and peak inverse voltage : A 20 vrms, 60 hz ac source is in series with an ideal diode and a 100 ohm resistance. Determine the peak current and peak inverse voltage (PIV) for the diode
Calculate the total current flowing through the battery : Consider a circuit with two resistors in parallel; R1=10 Ohm and R2=5 Ohm, Calculate the total current flowing through the battery
Explain how much heat energy is liberated : How much heat energy is liberated when 11.0 grams of manganese is used in the formation of Mn2O3. PHf° for Mn2O3 is -962.3 kJ/mol
Calculate the cost of energy for the period 1947 to 1994 : Construction on Hoover Dam was started in 1931 and finished in 1935, and the dam was in service from 1936. When completed, it was both the world's largest electric power producing facility and the world's largest concrete structure.
Find the power output from the power supply : A 31 μF capacitor is connected across a programmed power supply. find the power output from the power supply
How to calculate ph for the reaction : The burning of 80.3 g of SiH4 at constant pressure gives off 3790 kJ of heat. Calculate ?H for this reaction.
Find the power being absorbed by the resistor and inductor : A current source, Is =16.5cos(2300t) A, a resistor R=134Ω, and an inductor, L=0.12H are all in parallel. Assume steady-state conditions exist. At t=3.9ms, find the power being absorbed by the a.)resistor, b.)inductor, c.) sinsuoidal source
Determine the coil resistance : Two scales on a voltmeter measure voltages up to 21.0 and 30.7 V, respectively. Determine the coil resistance

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Resultant waveform of the odd harmonic series

Prepare an Excel graph showing the individual components and summated resultant waveform of the odd harmonic series resulting in an approximate square wave.

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Design a 2-digit 24 second shot-clock

Design a 2-digit 24 second "shot-clock" countdown timer with pushbutton controller.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Draw a relay construction diagram

Draw a relay construction diagram and briefly explain the operation of a relay.

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Impact of electron energy

Briefly discuss the impact of electron energy, electron current and target on the Bremsstrahlung generated.

  Traffic light controller

The schematic of the traffic light controller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd