Calculate the compressor outlet temperature

Assignment Help Mechanical Engineering

Reference no: EM13720688

If the isentropic efficiency of the compressor is 72% and the pressure ratio is 2.2:1, for an inlet pressure and temperature of 1 bar and 25^oC, calculate the compressor outlet temperature, the compressor outlet density and the power required to drive the compressor per unit mass of air flow through it..

Reference no: EM13720688

Questions Cloud

Percent increase in work input for same quantity of heat : The temperature inside a Carnot refrigerator is maintained at 5 degrees C by rejecting heat to the surrounings at an ambient temperature of 27 degrees C. The inside temperature now decreases to -13 degrees C with the ambient temperature remaining co..

What is the minimum cop acceptable for my heat pump : The heat pump for my house has 4 kW compressor motor. I wish to keep my house at 25 degrees C. My house loses energy to the cold winter night at 20 kW. What is the minimum COP acceptable for my heat pump?

Assume that the charge cooler incoming cooling water : Assume that the charge cooler incoming cooling water is at 45 oC and its effectiveness is 80% and the air pressure loss in charge cooler is 10 kN/m2, calculate the air temperature and density at the outlet of the charge cooler. Estimate the % increas..

Standard refrigerator and a window air conditioner problem : A kitchen contains a standard refrigerator and a window air conditioner. The refrigerator operates at steady state using 200 W of electric power and a COP of 3. If the kitchen is well insulated:

Calculate the compressor outlet temperature : If the isentropic efficiency of the compressor is 72% and the pressure ratio is 2.2:1, for an inlet pressure and temperature of 1 bar and 25oC, calculate the compressor outlet temperature, the compressor outlet density and the power required to drive..

Describe a physically-plausible situation : Describe a physically-plausible situation where the Reynolds number is (a) 1 (b) 10,000 (c) 1,000,000. For flow in tubes/pipes/ducts, use Red For flow over/along long/blunt objects, use Rel.

For water at room temperature : For flow of viscous fluids through a 5 cm diameter pipe, for what flow rate in m3/h would we expect transition to turbulence?

What will be the velocity and flow rate for the model : A dam spillway is tested with a 1/30th scale model, matching the Froude number. The flow over the dam has an average velocity of 0.6 m/s and a volume flow rate of 0.08 m^3/s.

What pressure should the air in the wind tunnel : A model of an airplane is to be tested at 20°C in a wind tunnel. The model is built to 1/12th scale. In order to match both the Mach number and the Reynolds number of the plane, the wind tunnel is pressurized. To what pressure (in atm) should the air..

User Account

All Pages