Calculate the change in the enthalpy and the change in

Assignment Help Mechanical Engineering
Reference no: EM13628222

1) One mole of a monatomic ideal gas is subjected to the following sequence of steps:

a. starting at 300 K and 10 atm, the gas expands freely into a vacuum to triple its volume.

b. The gas is next heated reversibly to 400 K at constant volume.

c. The gas is reversibly expanded at constant temperature until its volume is again tripled.

d. The gas is finally reversibly cooled to 300 K at constant pressure.

Calculate the values of q and w and the changes in U, h and S.

2) Calculate the change in the enthalpy and the change in entropy when one mole of SiC is heated from 25 degree Celcius to 1000 degree Celcius. The constant pressure milar heat capacity of SiC varies with temperature as Cp= 50.79 + 1.97*10^-3T -4.92*10^6T^-2 + 8.20*10^8T^-3 J/mole.K.

Reference no: EM13628222

Questions Cloud

A 600kg car traveling at 30 ms is going around a curve : a 600kg car traveling at 30 ms is going around a curve having a radius of 120m that is banked at angle of 25 degrees.
The coefficient of kinetic friction for the horizontal : an object with a mass of 10.0 kg is at rest at the top of a frictionless inclined plane of height 8.00 m and an angle
The production available in each department each month and : the weinberg electronics corporation manufactures four highly technical products that its supplies to aerospace firms
Suppose that a nickel filter is required to produce an : 1. graphically verify moseleys law for the k beta1 lines of cu mo and w.2. acalculate the mass an linear absorption
Calculate the change in the enthalpy and the change in : 1 one mole of a monatomic ideal gas is subjected to the following sequence of stepsa. starting at 300 k and 10 atm the
If the period of a 10m long pendulum is 18s on an asteriod : if the period of a 10m long pendulum is 18s on an asteriod then what is the acceleration due to gravity on the
Find the overall efficiency of the pump disregard friction : a storage tank is 40 feet above a river. water is pumped from the river to the storage tank at a rate of 0.095m3s. the
If 70 percent of the population of a large community is in : if 70 percent of the population of a large community is in favor of a proposed rise in school taxes using the normal
A 320 kg child slides down a long slide in a playground she : a 32.0 kg child slides down a long slide in a playground. she starts from rest at a height h1nbsp of 21.00 m. when she

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the work done during the process determine the

a piston-cylinder device initially contains 1.2 kg of steam with a volume of 0.2 m3. the mass of the piston is such

  What is the mass flow rate of oxygen

What is the mass flow rate of oxygen in lbm/s? Note that the inside diameter of a nominal 2 inch schedule 40 steel pipe is 2.067inches. Assume ideal gas principles apply.

  If the efficiency of this engine is 58 of the efficiency

in one cycle a heat engine absorbs 480 j from a high-temperature reservoir and expels 300 j to a low-temperature

  Explain tensile force and corresponding normal stress

Determine the magnitude of tensile force and corresponding normal stress of a wire A 28-ft length of 0.25-in

  Determine the maximum theoretical power that can be

steam at mpa 500 degrees c enters an insulted turbine operating at steady state with a mass flow rate of 7 kgs and

  One kg steam with a quality of 02 is heated in a

one kg steam with a quality of 0.2 is heated in a pistoncylinder vessel at a constant pressure of 200 kpa unit the

  Large wind turbines with blade span diameters of over 100 m

large wind turbines with blade span diameters of over 100 m are available for electric power generation. consider a

  At t 0 a force of the form f bt2e-lambdat is applied in

a particle of mass m is at rest at the origin of a coordinate system.nbsp at t 0 a force of the form f bt2e-lambdat

  The engine is shut down when the boats velocity has

a boat is subject to hydrodynamic drag forces of f 40v2n where v is the magnitude of velocity in ms. the boats mass is

  A vapor-compression refregeration ie reverse rankine system

a vapor-compression refregeration i.e. reverse rankine system circulates refrigerant 134a at a rate of 6kgmin. the

  A bar of steel 3 in 762mm in diameter is to be machined at

1 a bar of steel 3 in 76.2mm in diameter is to be machined at 90 fpm 0.5 msec. what spindle speed should be

  What is the volume of the box

Identify the mass properties that would be used to determine an appropriate size box to package 60 ABS Plastic (0.038 lb/in3) blanks and to ship them at $1.15 per pound.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd