Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A modulator transmits symbols, each of which has 64 different possible states, 15,000 times per second. Calculate the baud rate and the bit rate.
A sinusoidal current is zero at t = -0.625 s and increasing at a rate of 8000pi A/s. The maximum amplitude of the current is 5 A. a. What is the frequency of i in radians per second b. What is the expression for i
Using MultiSim (I am somewhat familiar with this program), connect the circuit drawn in Step 1 using AND gates, NOR gates, and inverters. Connect a logic switch to each input and an LED monitor to the output.
(a) A Ge bar 0.1 cm long and 100 m2 in cross-sectional area is doped with 1×1017 cm-3 gallium. Find the current at 300 K with 10 V applied. (b) Upon a steady illumination uniform excess carriers are generated in the Ge bar.
Suppose that a voice signal normally occupies 30 kHz of bandwidth and has a signal-to-noise ratio of 20 dB. Spread-spectrum techniques are used to increase its bandwidth to 2 MHz. (a) What is the signal-to-noise ratio of the spread signal
If the total power amplification through the receiver stages is G_R find the output power of the receiver. If the noise power at the output is identical to the noise power at the input of the receiver, find the NF for the receiver.
The capacitor in an RC circuit (R=10.0k Ohms and C=25.0uF) is initially uncharged. Determine the charge and current flowing in the circuit at 0.40 time constants (t=0.40 tau) after the circuit is connected to a 9.00 V battery.
With a 500hp shunt wound DC motor, at 1800rpm, 500Vdc, FLA is 800Adc, Ra is 0.025 and Rf is 400. What would Va need to be if you wanted the motor to operate at 1000rpm at rated torque. Keeping the field current constant.
One reason that the maximum electric field is important is because of the possibility of impact ionization, which may be desired or undesired in a particular application. The process of impact ionization is dependent on the electric field
At the instant shown, car A has a speed of 20km/h, which isbeing increased at a rate of 300km/h2 as the car entersan expressway. At the same instant, car B is decelerating at250 km/h2 while traveling forward at 100 km/h.
The voltage across a resistor is given by Ohm's Law: V=R I. Write a program that asks for resistance R in ohms, and current I in amps for several resistors, then calculates and displays the voltage across each resistor.
If you have a 30 VDC - 4A power supply and need to power two 24VDC - 0.8A MFC (mass flow controller), create a circuit that divide the voltage and can handle the power.
Three single phase transformers are used to form a three-phase transformer bank rated 13.8kV (delta)/120kV (wye). One side of the transformer bank is connected to a 120kV transmission line.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd