Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. An amplifier has cutoff frequencies of 120.0 Hz and 1.200 kHz. Calculate the bandwidth and center frequency of the amplifier.
2. The upper cutoff frequency of an amplifier is 8.000 MHz and its center frequency is 1 MHz. Calculate its lower cutoff frequency and itsbandwidth.
3. An NPN CE amplifier has a voltage gain of 32 and Cbc = 12 pF. What is the Miller capacitance seen by the base and seen by the collector?
A single-phase source is connected to an electric load. The load draws a 0.6 oer-unit current at 1.10 per-unit voltage while taking real power of 0.5 per-unit at a lagging power factor. Choose a base voltage of 12.47KV and a current of 100A.
An altimeter can measure 0-100m; using a signal conditioner, this high position is distributed over a voltage range of 0-5V. If an ADC covering the same voltage range outputs 1000 0000, what is the distance measured
If you have a purely inductive load with a reactance of 2/377 O connected to the 120Vrms 60 Hz (i.e., f = 377 rad/sec) AC line, what value of capacitor (in Farads) must be put in parallel with it to set the power factor to one
a. What is the expected amplification of a BJT transistor amplifier if the dc supply is set to zero volts. b. What will happen to the output ac signal if the dc level is insufficient.
If the system is released from rest, determine the velocity of block A after it has moved 2m. Assume that the coefficient of kinetic friction between block A and the plane is 0.25 and that the pulley is weightless frictionless.
In comparing the behaviour of an n-channel MOSFET with a p-channel device having identical geometry and threshold voltage, it is found that the n-channel FET has a greater drain current than that of the p-channel FET.
Early scientific researchers hypothesized that electricity was an invisible fluid that could move through certain substances. Those substances "porous" to this "fluid" were called conductors, while substances impervious to this "fluid" were called..
If i were to have a plane wave in free space with the following E field intensity: E = 15cos(ωt + 10πz + θ) in the y direction V/m and H at t=0 z=1.15m is 0.02 A/m how can I find the initial phase, θ
A three-phase ,600MVA,13.8KV Ac generator has a synchronous reactance of 2.0 per unit. The generator is connected to a system for which specified base fare 100MVA and 345KV.
1) What type of chemical reaction is taking place 2) How many liters of 0.100 M HCl would be required to react completely with 5.00 grams of calcium hydroxide 3) If I combined 15.0 grams of calcium hydroxide with 75.0 mL of 0.500 M HC..
3-phase line, which has an impedance of 2 + j4 per phase, feeds two balanced three-phase loads that are connected in parallel. One of the loads is Y-connected with an impedance of (20 + j40) per phase
Why then do we even use JFETs as amplifiers What is it that make them attractive even though they are non-linear? How do we minimize the effect of their non-linearity
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd