Reference no: EM13545531
Problem
1 in. diameter, 20 in. length, steel and aluminum bars are fitted between rigid plates(" just touching") at 70 F. The bars are then heated from 70 F to 300 F.
1. Calculate the axial stress in each bar.
2.Calculate the change in diameter in each bar.
The bottom bar is made up of an aluminum bar and a steel bar, each 10 in. long placed in the parallel configuration at 70 F. That is also heated to 300 F.
1. Calculate the axial stress in each bar.
2. Calculate the change in diameter in each bar.
3. Calculate the new location of the interface - does it move left or right and how much?
For alum: CTE = 0.0000129 per deg F, E= 10.5E6 psi, poisson ratio= 0.3
For steel: CTE = 0.0000065 per deg F, E= 29.5E6 psi, poisson ratio = 0.3
|
Prepare two pages about photorefractive material
: Prepare two pages about photorefractive material with references - Two wave mixing
|
|
Evaluate the heat transfer per unit mass and work per unit
: A quality of water within a piston-cylinder assembly executes a Carnot power cycle. During isothermal expansion, the water is heated from saturated liquid at 50 bar until it is a saturated vapor. The vapor then expands adiabatically to a pressure of ..
|
|
Find the stress induced in the aluminum rod
: Find the stress induced in the aluminum rod if, after the gap is closed, the two segments are welded together, and then a leftward force is applied of the same magnitude needed to close the gap. Assume the rod segments remain aligned during loading.
|
|
Design the pins so that the ledge can support doug
: Assume the ledge has the dimensions shown and is attached to the building with a series of equally spaved pins around the circumference of the building.
|
|
Calculate the axial stress in each bar
: The bottom bar is made up of an aluminum bar and a steel bar, each 10 in. long placed in the parallel configuration at 70 F. That is also heated to 300 F.
|
|
Plot the shear-force and bending-moment diagrams
: Plot the shear-force and bending-moment diagrams for the beam and derive equations for the shear force V and the bending moment M for any location in the beam
|
|
Estimate the total cost and cost per linear foot for furnush
: Estimate the total cost and cost per linear foot for furnushing and driving steel-sheet piling for construction of the basement of a building, 150 by 240 ft. the piles will be 22 in. wide, 18 ft. long, and weigh 40.3 Ib/Lin ft. the piles will be driv..
|
|
What is your speed in mph and ft/s need formulas
: You are driving a car your metered fuel flow is 5.97x10^5 csf if at the speed you are driving you are getting 40mpg what is your speed in mph and ft/s need formulas.
|
|
Find the intersection. how do you find the system curve
: Find the cooling load (in tons of refrigeration) for a room supplied with 10,000 CFM of 95 DB outside air with ratio of 105 gr/lb. The room is to be maintained at 78 DB and humidity ratio of 71.5 gr/lb. The room calculated sensible heat load is 108,0..
|