Reference no: EM13992424
Problem 1
A screw thread is cold rolled on a 1015 low-carbon steel bolt of 6.25 mm diameter. Observation shows that the length of the contact zone between die and screw blank is L = 1.25 mm. The average strain hardening during rolling corresponds to a strain of
? = 0.4.
Calculate:
(a) the applicable flow stress, and
(b) the average interface pressure in the contact zone.
Determine:
(c) if there is any danger of internal fracture (make a sketch to illustrate the point).
Problem 2
Circular blanks (slugs) of 1100Al, diameter d = 25 mm and thickness h = 3 mm, are to be mass-produced as the starting material for toothpaste-tube extrusion. The available presses are of 500 N capacity and can take a maximum 220 mm wide strip. Economy of material utilization increases with increasing number of rows cut from one strip width.
(a) Calculate the torque required for blanking a single slug.
(b) Estimate the number of slugs that can be blanked simultaneously with the available press.
(c) Suggest the optimum layout for the slugs if the web (remaining material between cuts at edges) is approximately h, but seldom less than 1 mm.
|
Module title english legal systems, method and skills
: What was the effect of the decision of the Supreme Court in this case on the decision of the Court of Appeal in this case? What was the effect of the decision of the Supreme Court in this case on the Court of Appeal’s decision in Danesh?
|
|
Identify a minimum of three lenders
: Identify (and clearly indicate them in your submission) a minimum of three lenders Kyle could borrow the money from and discuss the mortgage alternatives available and the respective terms and applicable interest rates;
|
|
Please answer the following hypothetical
: You are the Police Chief of the Los Angeles Police Department. You have apprehended a suspect you have reason to believe is the member of a major terrorist organization.
|
|
Write a random file
: Write a program in C that write a random file (test write speed) then read that same file and calculate the speed of the write. (please DON'T use hdparm to test the read speed)
|
|
Calculate the applicable flow stress
: A screw thread is cold rolled on a 1015 low-carbon steel bolt of 6.25 mm diameter. Observation shows that the length of the contact zone between die and screw blank is L = 1.25 mm. The average strain hardening during rolling corresponds to a strain o..
|
|
Sources of revenue as part of the internal analysis
: Explain how you would conduct an internal strategic management audit and competitive strength assessment. As a business leader, explain how you would organize a strategic internal information scanning system. Why is it important to understand the 5 s..
|
|
Epidemiologic planning model and the precede-proceed model
: How are the Epidemiologic Planning Model and the Precede-Proceed Model similar? How are they different? From you professional experience, which one has the greatest ability to deliver optimal results for an HCO?
|
|
What are the key components of an internal audit
: What are the key components of an internal audit? What are the implications of having a thorough understanding of each? Using your firm (or a firm that you familiar with), select a significant company resource (such as engineering capability, or supp..
|
|
The low fare airlines-often termed low-cost-carriers
: Since deregulation, the low fare airlines, often termed low-cost-carriers, have captured significant market share from the more established network carriers in the U.S. and Europe. Discuss some economic aspects that have led to the success of low far..
|