Calculate the absolute pressure in the tank if the fluid in

Assignment Help Mechanical Engineering
Reference no: EM131095690

Qus 1: The pressure in a tank is measured with a manometer, as shown in Figure 1. Calculate the absolute pressure in the tank if the fluid in the manometer arm is 35cm (a) lower and (b) higher (as shown) than the tank.

2414_Untitled picture.png

Qus 2: Show that the friction factor f for the laminar flow can be given by f=64/ReD

Reference no: EM131095690

Questions Cloud

Find the velocity of money : If the money supply is $500 and nominal income is $3,000, the velocity of money is and In Irving Fisher´s quantity theory of money, velocity was determined by
Discuss how the biblical stewardship principle impacts : Discuss how the Biblical STEWARDSHIP principle (God is owner of all) impacts business decisions and puts additional constraints on business behavior for the Christian. Because all property is ultimately God's and profits are due to God's grace, sh..
Find the value of the canadian dollar : If the 2005 inflation rate in Canada is 4 percent, and the inflation rate in Mexico is 2 percent, then the theory of purchasing power parity predicts that, during 2005, the value of the Canadian dollar in terms of Mexican pesos will
Study guide suggests to begin the drafting process : There are two portions to this assignment:  the introduction to the paper and the review of literature.
Calculate the absolute pressure in the tank if the fluid in : The pressure in a tank is measured with a manometer, as shown in Figure 1. Calculate the absolute pressure in the tank if the fluid in the manometer arm is 35cm (a) lower and (b) higher (as shown) than the tank.
Plan and collaborate a professional development session : Your principal has asked you to facilitate a Plan and collaborate a professional development session for a group of teachers that relates to curriculum standards, instruction, and/or assessment of learning.
Determine the capacitance to neutral of a three-phase line : What is [he charging current of the line (in A/km) at 60 Hz and 100 kV line to line?
What is the total common food sense roared by me company : What contribution margin per pound of raw material is awned by eada product? What h the total traceable fixed overhead cost incurred by Ace Company? What is the total common food *sense roared by Me Company?
Model of the money supply process : An assumption in the model of the money supply process is that the desired levels of currency and excess reserves

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Refrigerant enters the condenser of residential heat pump

Refrigerant-134a enters the condenser of a residential heat pump at 900 kPa and 40°C at a rate of 0.02 kg/s and leaves at 900 kPa as a saturated liquid. If the compressor consumes 1.2kW of power, determine (a) the COP of the heat pump and (b) the rat..

  A paperclip is made of wire 125mm in diameter if the

a paperclip is made of wire 1.25mm in diameter. if the original material from which the wire is made nbspwas 15mm in

  Find relative humidity at outlet and amount of water added

Air at 40 °C, 1 bar, and 10% RH goes through an evaporative cooler, and the outlet air is cooled to 27 °C. Find (a) the relative humidity at the outlet, and (b) the amount of water added (kg H20 per kg of air).

  An energy input as heat of 42 kj was required determine the

ln a study of the properties of a liquid a 2-kg sample of liquid was heated at a constant pressure of 1 atm from 500 to

  Estimate the cost an oil change 5 quarts of oil and new oil

estimate the cost an oil change 5 quarts of oil and new oil filter for your automobile at a local service station.it

  The refrigerant leaves the condenser at 07 mpa 26 degc

consider a non-ideal vapor-compression cycle where refrigerant 134a flows at a rate of 0.05 kgs. the refrigerant enters

  Find the discharge for free flow

A 3-inch diameter orifice cut in a thin orifice plate conveys flow from a deten- tion basin with water level at elevation 472.00 feet. The center of the orifice is at elevation 467.50 feet. Find the discharge for free flow.

  Consider a heat exchanger that uses hot air to heat cold

consider a heat exchanger that uses hot air to heat cold water. air enters this heat exchanger at 20 psia and 200

  Working fluid passing through the steam generator

Water is the working fluid in an ideal Rankine cycle. Superheated vapor enters the turbine at 10 MPa, 4808C, and the condenser pressure is 6 kPa. Determine for the cycle (a) the rate of heat transfer to the working fluid passing through the stea..

  What is the average specific volume of the fluid in the

the old rigid tank problem a tank has a volume of 600 gallons and holds 300 lbm of water at 40 psig pressure. what is

  Specific volume of superheated water vapor

If we want to find the specific volume of superheated water vapor, which below is the most accurate method:

  A fixed quantity of air at t1 60oc and p1 158 kpa is

a fixed quantity of air at t1 60oc and p1 158 kpa is heated at constant temperature in a piston-cylinder assembly

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd